Abstract:An analysis of the hot flow forming of Mg-3.0 Al-1.0 Zn-0.3 Mn（AZ31 B） alloy was conducted by experiments and numerical simulations. The effects of different thickness reductions on the microstructure and mechanical properties were investigated at a temperature of 693 K, a spindle speed of 800 rev/min and a feed ratio of 0.1 mm/rev. Thickness reductions have great influence on the uniformity of microstructure along the radial direction（RD） and the grain sizes become refined and uniform when the thickness reduction reaches 45%. The c-axes of most grains are approximately parallel to the RD, with a slight inclination towards the axial direction（AD）. The best mechanical properties with UTS of 280 MPa and YS of 175 MPa near the outer surface while 266 MPa and 153 MPa near the inner surface have been achieved due to grain refinement and texture. Moreover, the material flow behavior and stress/strain distributions for singlepass reductions were studied using the ABAQUS/Explicit software. The calculated results indicate that the materials mainly suffer from triaxial compressive stresses and undergo compressive plastic strain in RD and tensile strains in other directions. The higher stress and strain rate near the outer surface lead to more refined grains than that of other regions along the RD, whereas the orientation of the maximum principal compressive stress leads to a discrepancy of the grain orientations in RD.

Press Forming in AZ31B Wrought Magnesium Alloy

Experimental and numerical study of warm deep drawing of AZ31 magnesium alloy sheet

Warm deep drawing of square parts of AZ31 magnesium alloy sheet adopting variable blank holder force

Analysis of Section Extrusion and Microstructure and Mechanical Properties of AZ31 Magnesium Alloy

Experimental Research on Formability of Stamping of AZ31B Magnesium Alloy Sheets

Influence of Microstructure and Mechanical Properties on Formability in High Strain Rate Rolled AZ31 Magnesium Alloy Sheets

Effect of Rolling Method on Microstructure and Properties of AZ31 Magnesium Alloy Thin Sheet

Microstructures, Tensile Properties and Forming Process of AZ31 Alloy Sheets

Grain Refinement and Orientation of AZ31B Magnesium Alloy in Hot Flow Forming under Different Thickness Reductions

Mechanical Anisotropy and Deep Drawing Behaviors of Az31 Magnesium Alloy Sheets Produced by Unidirectional and Cross Rolling

Fabrication of Excellent Mechanical Properties AZ31 Magnesium Alloy Sheets by Conventional Rolling and Subsequent Annealing

Isothermal Deep Drawing Process of AZ31 Mg Alloy Sheet

Local Hot Gas Forming of Long Axis Bellow with Non-uniform Temperature

Microstructure and Mechanical Properties of Extruded Az31 Magnesium Alloy Sheet

Magnetic Pulse Forming of AZ31 Magnesium Alloy Shell by Uniform Pressure Coil at Room Temperature

Mechanical Properties and Constitutive Analysis of Extruded AZ31B Magnesium Alloy

Microstructure And Mechanical Properties Of Az31 Magnesium Alloy Sheet By Hot Rolling

Experimental and Numerical Research on Process Formability in Magnetic Pulse Forming of AZ31 Magnesium Alloy Sheets

Microstructures and Mechanical Properties of Hot Rolled AZ31 Mg Alloy Sheets

Effect of Lubrications on Quick Plastic Forming Behavior of AZ31 Magnesium Alloy Sheet

Effect of Extrusion Deformation on Microstructures and Properties of AZ31 Magnesium Alloy