Abstract:A milling force measurement tool system is designed with an elastic beam structure, which is divided into a two-end ring hoop compression sensor mode and a two-end square hoop compression sensor mode to improve the strain sensitivity. A simplified mechanical model of the elastic beam is established, and the relationship between the strain and force of the elastic beam under the action of three cutting force components is investigated, which can act a guide for subsequent milling force measurement tool system calibration tests. Thin-film strain sensors occupy a central position in the milling force measurement tool system, which consists of a substrate, transition layer, insulating layer and resistance grid layer. The resistance grid layer has a particularly significant effect on the thin-film strain sensor's performance. In order to further improve the sensitivity of thin-film strain sensors, the shapes of the substrate, the transition layer, the insulating layer and the resistance grid layer are optimized and studied. A new thin-film strain sensor is designed with a resistance grid beam constructed from an insulating layer and a resistive grid layer double-end-supported on the transition layer. The flow of the wet-etching process of thin-film strain sensors is studied and samples are obtained. The surface microforms of the sensor samples are observed by extended depth-of-field microscopy, confocal microscopy and atomic force microscopy. It can be seen that the boundary of the resistance grid layer pattern is tidy and has high dimensional accuracy, thus enabling the basic achievement of the expected effect of the design. The electrical performance of the samples is tested on an experimental platform that we built, and the results show that the resistive sensitivity coefficient of the samples is increased by about 20%, to 51.2%, compared with that of the flat thin-film strain sensor, which fulfils the design's requirements.

Design of a micromechanical inclinometer with two strained silicon beams

Design of a Two Dimension Si Micromechanical Inclinometer

Single Chip-Based Nano-Optomechanical Accelerometer Based on Subwavelength Grating Pair and Rotated Serpentine Springs

Monolithic Integrated Micro-Opto-Electromechanical Accelerometer Based on Michelson Interferometer Structure

MEMS inclinometer based on a novel piezoresistor structure

A Micromechanical Structure Eliminating Lateral Effect of Silicon Accelerometer

Design and Simulation of a Silicon Beam Resonant Accelerometer

Design And Fabrication Of A Slanted-Beam Mems Accelerometer

Evaluation of Mechanical Properties and Strain Criterion for Realibility Design of Micromachined Polysilicon Thin Films

Dimension effect on mechanical behavior of silicon micro-cantilever beams

A micromachined silicon resonant accelerometer

Design and fabrication of a novel silicon probe for micromachined surface profilers

Design of a Beam-Membrane Piezoresistive Accelerometer Based on MEMS Technology

Structural Design and Optimization of the Milling Force Measurement Tool System Embedded with Thin-Film Strain Sensors

An integrated push-to-pull micromechanical device: Design, fabrication, and in-situ experiment

A High-Performance Micromachined Piezoresistive Accelerometer with Axially Stressed Tiny Beams

Improvement of Stresses in Multilayer Structures with SiO/sub 2//pt/pb(zr,ti)o/sub 3//pt Thin-Film Stacks for Micro-Scanner Actuators

Micro-machined Resonant Out-of-plane Accelerometer with a Differential Structure Fabricated by Silicon-on-insulator–mems Technology

Design of Three-dimensional Isotropic Microprobe Based on Three-Flexible-Hinge Suspension for Measurement of Microstructures

Analysis On Twin-Mass Structure For A Piezoresistive Accelerometer

Structural Design and Testing of a Micromechanical Resonant Accelerometer