Abstract:High quality lumbers produced from Eucalyptus plantations can be used to make higher value-added solid wood products. Moisture flow affects shrinkage, deformation, and quality of Eucalyptus wood during conventional drying. In this study, 50 and 100 mm long samples were dried using a conventional drying method. The drying curves, drying rate, moisture content (MC) gradient and distribution, moisture flow, and shrinkage during the drying process were investigated. The results show: Drying was much faster in the first 15 h for all samples and became slow as MC decreased. The drying rate above fiber saturated point (FSP) was about 3.5 times of that below FSP for all samples. The drying rate of 50 mm samples above and below FSP is 1.40 and 1.33 times of 100 mm samples; MC gradients are greater in tangential, radial directions, and cross-sections for both samples when the MC is above FSP, especially at an average MC of 50%. MC gradient along the tangential and radial direction depends on the samples size and MC stages. The short samples have much greater MC gradients than the longer samples above FSP. Moisture distributions on the cross-sections of wood coincide with the moisture gradient in the cross-sections. At an average MC of 50%, the moisture distributions of 50 mm are highly uneven, while they are relatively even in the middle of 100 mm samples, and become much more even at the end of the sample. Moisture distributions become even as MC decreases in all of the samples. Water migration directions vary by state of water. In the short samples, most free water migrates more in the fiber direction from the wood center toward the end surfaces, but bound water diffusion becomes weak. The collapse in the 50 mm samples is significantly larger than that in the 100 mm samples, indicating that the collapse is affected by the dimension of the sample.

The Relationship between Location in a Kiln and Drying Defects on Small-diameter Daimyo Oak Lumber

Crack Propagation And Fracture Process Zone (Fpz) Of Wood In The Longitudinal Direction Determined Using Digital Image Correlation (Dic) Technique

High-strain Rate Compressive Behavior of Douglas Fir and Glubam

Moisture changes and surface checking development during drying of Masson pine wood

Impact of airflow on hem-fir kiln drying

Experiment on Effect of Humidity on Dowel Bearing Strength of Glued Laminated Timber

The Characteristics of Moisture and Shrinkage of Eucalyptus urophylla × E. Grandis Wood during Conventional Drying

Kiln-drying effectiveness as influenced by moisture content and density variation within a Scots pine timber batch

Investigation on the char crack growth of densified wood

Free drying shrinkage performance of Pinus sylvestris L. under different temperature and humidity conditions

Study on free shrinkage and rheological characteristics of Eucalyptus urophylla ×E. grandis during conventional drying

Effect of the drying condition on the strength properties of Japanese larch board after vacuum heat treatment

Experimental study on the characteristic values of partial compression perpendicular to the grain of hardwood with edge distance parallel and perpendicular to the grain

Analyzing the impact of veneer layup direction and heat treatment on plywood strain distribution during bending load by digital image correlation (DIC) technique

Numerical Modelling of Drying Induced Cracks in Wood Discs Using the Extended Finite Element Method

Effects of pre-steaming treatment on high-temperature and low-humidity drying characteristics of super-heavy timber with boxed-heart of Korean red pine and Douglas-fir

XFEM Study of Crack Propagation in Logs after Growth Stress Relaxation and Drying Stress Accumulation

Field test of sticker thickness in kiln drying of southern pine

Experimental study on fire resistance of traditional timber mortise-tenon joints with damages

Machine Vision for Knot Detection and Location in Chinese Fir Lumber

Elm wood ( Ulmus rubra ) vacuum drying at 40 °C studied by time domain nuclear magnetic resonance (TD-NMR)