Abstract:Accurately measuring the cutting temperature in micro cutting zone is crucial for characterizing and optimizing the cutting status during ultra-precision machining. This work proposes an innovative method for self-sensing of cutting temperature using a locally boron-doped diamond tool. A longitudinal layered deposition synthesis methodology, instead of the traditional growth method under high temperature and high pressure conditions (HTHP), was developed to enable the fabrication of the locally boron-doped diamond tool. The doping contents, lattice integrity, and electrical properties of the diamond were characterized. Owing to the inherently low thermal capacity and quick carrier migration induced by the thin-layer structure for sensing temperature, the diamond tool has the advantages of rapid response and enhanced sensitivity, compared with traditional cutting temperature measurement technologies. An insulated diamond tool edge without boron doping enables to accurately measure cutting temperature for various conductive materials in ultra-precision cutting processes. The locally boron-doped diamond tool was employed for in-process monitoring of the temperature in micro cutting zone during ultra-precision machining processes. The experimental results demonstrated the capabilities of in-process cutting temperature monitoring of conductive materials using the diamond tool, as well as the high-sensitivity identification of micro/nano morphologies and defects on machined surface based on the measured temperature. It provides a potential approach for advanced status analysis and diagnosis in the process of ultra-precision machining.

Investigation on Partitioned Distribution of Cutting Heat and Cutting Temperature in Micro Cutting

The heat partition into cutting tool at tool-chip contact interface during cutting process: a review

Research on 3D Numerical Simulation and Experiment of Cutting Temperature for High Speed Milling of Aerospace Aluminum Alloy

Investigation of heat partition and instantaneous temperature in milling of Ti-6Al-4V alloy

Experimental Studies of Cutting Temperature During High-Speed Milling of Aerospace Aluminum

Tool edge radius effect on cutting temperature in micro-end-milling process

Study on Cutting Temperature Modeling of Machined Workpiece in End Milling In-Situ TiB2/7050Al MMCs

Analyzing The Effect Of Tool Edge Radius On Cutting Temperature In Micro-Milling Process

An Investigation of Temperature and Heat Partition on Tool-Chip Interface in Milling of Difficult-To-Machine Materials

Molecular Dynamics Simulation of Heat Distribution During Nanometric Cutting Process

A Locally Boron-Doped Diamond Tool for Self-Sensing of Cutting Temperature: Lower Thermal Capacity and Broader Applications

Investigation on Surface Quality of High-Speed Cutting Titanium Alloy Ti6Al4V Based on Split-Hopkinson Pressure Bar

Optimizing Heat Transfer Rate in an Internally Cooled Cutting Tool: FE- Based Design Analysis and Experimental Study

Advance in experimental research on cutting temperature of titanium alloys

Back Chip Temperature in Environmentally Conscious Turning with Conventional and Internally Cooled Cutting Tools

Internally Cooled Tools and Cutting Temperature in Contamination-Free Machining

Modeling and Experimental Analysis the Effect of Minimum Chip Thickness on Cutting Temperature in Micro-End-Milling Process

The Effects of Heat Generation on Cutting Tool and Machined Workpiece

Simulation and Experiment Analysis on Thermal Deformation of Tool System in Single-Point Diamond Turning of Aluminum Alloy

The Study of the Influence of Tool Wear on Cutting Temperature in Diamond Ultra-Precision Cutting of Aluminum Alloy Mirror

An improved analytical model of cutting temperature in orthogonal cutting of Ti6Al4V