Abstract:The flow condensation heat transfer coefficient of R134a inside two helical micro-fin tubes with outer diameter of 6.35 mm and helical angles of 18o and 28o respectively were experimentally studied at a high mass flux ranging from 500 to 1100 kg m−2 s−1. The condensation temperatures are 35°C, 40°C and 45°C, and the vapor qualities ranges from 0.95 to 1.00 at the inlet section and from 0.00 to 0.05 at the outlet section. Experimental results show that there are annular and intermittent flow regimes inside the tube under experimental conditions, the ratio of annular flow region to the total heat transfer region is about 70%. The liquid film flow changes from rotational flow to coexistence of rotational and horizontal flows when the vapor quality is 0.475±0.08, 0.486±0.06 and 0.521±0.05, respectively and the corresponding saturation temperature is 35°C, 40°C and 45°C. Based on the experimental data, the heat transfer coefficient increases with increasing mass flux and fin helical angle, and with decreasing saturation temperature and Reynolds number of cooling water. In addition, the heat transfer coefficient of annular flow is greater than that of intermittent flow, in other words, the heat transfer coefficient increases with increasing vapor quality. The heat transfer coefficient obtained at high mass flux was compared with the calculated data of some published correlations used at low mass flux. It was found that most correlations underestimate the experimental heat transfer coefficient inside the micro-fin tube, and these prediction deviation increases with increasing mass flux and fin helical angle. By introducing some dimensionless numbers as well as considering the flow mechanism of liquid film inside the tube, two heat transfer coefficient correlations were proposed based on the experimental data. The ratio of liquid film thickness to fin height was used to characterize whether the liquid film flow is rotational flow or coexistence of rotational and horizontal flows in the proposed correlation, which shows a better prediction accuracy with a mean deviation of less than 7.3%.

Simulations and Experiments of Laminar Heat Transfer for Therminol Heat Transfer Fluids in a Rifled Tube

Simulation And Analysis On Heat Transfer In Laminar Oscillatory Flow In-Tube

Experimental and Numerical Investigation on Heat Transfer of Therminol Heat Transfer Fluid in an Internally Four-Head Ribbed Tube

Experimental Study of Condensation Heat Transfer of R134a Inside the Micro-Fin Tubes at High Mass Flux

Theoretical and Experimental Analyses of Two-Phase Flow Condensation Heat Transfer Inside the Horizontal Micro-Fin Tube

Flow boiling heat transfer in a vertical spirally internally ribbed tube

Numerical Analysis of Heat Transfer to Water Flowing in Rifled Tubes at Supercritical Pressures

Turbulent flow and heat transfer in discrete double inclined ribs tube

Experimental and Numerical Studies of Liquid Flow and Heat Transfer in Microtubes

Performance of single-phase turbulent flow heat transfer and frictional pressure drop in an internally ribbed tube

Experimental study on single-phase heat transfer performance of internal helically finned tubes covering low Reynolds number in turbulent flow

Convective Heat Transfer and Pressure Drop of a Tube with Internal Longitudinal Fins

EXPERIMENTAL STUDY OF LIQUID FLOW AND HEAT TRANSFER IN MICROTUBES

Numerical Heat Transfer Analysis of Laminar Film Condensation on a Vertical Fluted Tube

Prediction of fully developed turbulent heat transfer of internal helically ribbed tubes – An extension of Gnielinski equation

Numerical Investigation on Heat Transfer Characteristics of Liquid Metal Cross Flow over Tube Bundles

Laminar heat transfer characteristics of internally finned tube with sinusoidal wavy fin

Flow boiling heat transfer characteristics in vertical upward internally ribbed tube

Numerical Study of Thermal-Hydraulic Performance Improvement of Enhanced Surface Tubes

Experimental Investigation on Heat Transfer Characteristics of Low Mass Flux Rifled Tube with Upward Flow

Numerical Study On Low Reynolds Number Heat Transfer In Alternating Elliptical Axis Tube