Abstract:Blast furnace (BF) ironmaking is the most important process that produces hot metal (HM) from iron-bearing materials continuously, rapidly, and efficiently. To date, the process is considered to have reached its limit in view of the achieved high process efficiency. In addition, the required high-quality materials are expensive and gradually getting depleted. Hot gas injection (HGI) into the shaft of the BF is an emerging technology recognized potential to solve the aforementioned problems. However, so far, limited information and studies are available, most of which are preliminary studies with regard to the feasibility and aerodynamics of the technology. This hindered the understanding and thus the effective use of this technology. This work presents a numerical study of the multiphase flow, heat, and mass transfer in a BF by a CFD-based process model. The effects of injection composition in terms of CO and CO2 contents in HGI are studied first. The calculated results reveal that HGI of 100% CO delivers the best BF performance. Then, the effects of key variables in relation to HGI of 100% CO, including position, rate, and temperature, are systematically studied. The in-furnace states and overall performance parameters have been analysed in detail. The results show that, through appropriate control of the injection variables, it is possible to achieve improved BF performance including low fuel rate and high productivity, which are considerably affected by the HGI parameters. The BF process model is also demonstrated to be a cost-effective tool in optimizing the key variables of HGI in BF for obtaining optimum process efficiency.

Effect of Zinc Pot Designs on Flow and Temperature Distribution in Hot-Dip Galvanizing Process

Study of Flow and Zinc Dross Removal in Hot-Dip Galvanizing with Combined Traveling Magnetic Field

Computational Study of Hot Gas Injection (HGI) into an Ironmaking Blast Furnace (BF)

Simulation of the Flow-Heat Transfer Process in Billet Mold and Analysis of the Billet Rhomboidity Phenomenon

Effect of cooling pattern on centrifugal casting mold stress–strain distribution through computational fluid dynamics and finite element method analysis

Design Improvement of Four-Strand Continuous-Casting Tundish Using Physical and Numerical Simulation

Simulation of Temperature Field and Microstructure in Heavy Steel Ingots Solidification

Investigation on Heat Transfer in Molds with Different Water-Cooling Structures Under Billet High-Speed Continuous Casting

The Effect of Mold Structure and Cooling Parameters on Heat Transfer during Billet High-Speed Continuous Casting

Influence of Gating Geometry Variations on Flow Balancing of Horizontal Multi-gate Systems in Casting

Domination and Effect of Multi-parameters in Direct Chill Casting based on Establishment of Thermo Model by Numerical Simulation and Experiment

Numerical Simulation of the Flow Field in an Ultrahigh-Speed Continuous Casting Billet Mold

Experimental and Numerical Simulation Study on Uniformity of Temperature and Flow Field in an Advanced Packaging Electroplating Cell

Numerical Simulation of Heat Transfer Behavior in Hot Spot Zone of Converter Molten Bath

Effect of Furnace Gas Composition on Characteristics of Supersonic Oxygen Jets in the Converter Steelmaking Process

Effects of zinc-aluminium injection on corrosion behaviour and semiconductor properties of carbon steel in the PHT system of PHWR

Cfd Investigating the Effects of Different Mixing Vane Designs on the Localized Thermal-Hydraulic Characteristics in the Rod Bundles with Grid Spacer

Effect of Different Conditions on Heat Transfer Characteristics of Molten Zr-Stainless Steel Pool with Water Injection

Numerical simulation and experimental verification of the initial temperature distribution of castings during mold filling process

Numerical Simulation of Solidification and Macrosegregation in Water Cooled Heavy Steel Ingot

Numerical simulation on flow and heat transfer in twin roll strip casting and rolling molten pool with side dams vibrating