Experimental Study on Combustion Characteristics of Chinese RP-3 Kerosene

Ma Hongan,Xie Maozhao,Zeng Wen,Chen Baodong
DOI: https://doi.org/10.1016/j.cja.2016.02.003
IF: 5.7
2016-01-01
Chinese Journal of Aeronautics
Abstract:In order to illustrate the combustion characteristics of RP-3 kerosene which is widely used in Chinese aero-engines, the combustion characteristics of RP-3 kerosene were experimentally investigated in a constant volume combustion chamber. The experiments were performed at four different pressures of 0.1MPa, 0.3MPa, 0.5MPa and 0.7MPa, and three different temperatures of 390K, 420K and 450K, and over the equivalence ratio range of 0.6–1.6. Furthermore, the laminar combustion speeds of a surrogate fuel for RP-3 kerosene were simulated under certain conditions. The results show that increasing the initial temperature or decreasing the initial pressure causes an increase in the laminar combustion speed of RP-3 kerosene. With the equivalence ratio increasing from 0.6 to 1.6, the laminar combustion speed increases initially and then decreases gradually. The highest laminar combustion speed is measured under fuel rich condition (the equivalence ratio is 1.2). At the same time, the Markstein length shows the same changing trend as the laminar combustion speed with modification of the initial pressure. Increasing the initial pressure will increase the instability of the flame front, which is established by decreased Markstein length. However, different from the effects of the initial temperature and equivalence ratio on the laminar combustion speed, increasing the equivalence ratio will lead to a decrease in the Markstein length and the stability of the flame front, and the effect of the initial temperature on the Markstein length is unclear. Furthermore, the simulated laminar combustion speeds of the surrogate fuel agree with the corresponding experimental datas of RP-3 kerosene within ∼10% deviation under certain conditions.
What problem does this paper attempt to address?