Abstract:Understanding the distribution of cutting force provides a foundation for the design and optimization of cutterhead layout. The simulation of rotary cutting with a large cutting radius remains a challenge for laboratory tests. In this study, taking the driving condition of the Mawan Tunnel located in the Guangdong-Hong Kong-Macao Greater Bay Area as a case study, a full-scale rotary cutting platform with large cutting radius was used to investigate the rock-breaking effects. Rotary cutting with cutting depths of 1–8 mm and cutting radii of 200–1400 mm were carried out on the granite testing platform using a 19-in disc cutter. The normal force, rolling force, and side force during the cutting process were systematically monitored. Moreover, the time–frequency characteristics of the rock breaking process and the effects of cutting depth, cutting radius and stress state on the average and peak loads were investigated. The results show that the average normal force and rolling force increased with increasing cutting depth, while the side force was less affected by cutting depth through the Boltzman model analysis. The average normal force and rolling force were not significantly affected by the cutting radius, but the average side force decreased as a power function with increasing cutting radius, and showed a stable side force when the installation radius exceeded 1000 mm. The dominant frequency of the cutting force was 0–1.2 Hz, exhibiting notable low-frequency characteristics. Additionally, the ratio of peak to average (RPA) with respect to triaxial cutting force demonstrated an increase with the growth of cutting depth, while RPA in terms of side force exhibited a corresponding growth with the increasing cutting radius. In particular, the cutting force characteristics of the cutterhead obtained in this study can inform the layout of disc cutters and real-life TBM operations, thereby avoiding severe overloading of internal disc cutters.

Study On Rock-Breaking Simulation And Experiment Of Double Disc Cutter Of Tbm

Research on Numerical Simulation of Rock Breaking Using Tbm Disc Cutters Based on Udec Method

Theoretical and Applied Research of the Deformation of the Continuous Cutterhead of TBM

Comparative Study of the Rock-breaking Mechanism of a Disc Cutter and Wedge Tooth Cutter by Discrete Element Modelling

The energy method to predict disc cutter wear extent for hard rock TBMs

Investigation on Two-Step Simulation Modeling Method for Rock Breaking by TBM Disc Cutters Assisted with Laser

Research on Rock-Breaking Characteristics of Cutters and Matching of Cutter Spacing and Penetration for Tunnel Boring Machine

Experimental and Numerical Investigations on Rock Breaking of TBM Disc Cutter Based on a Novel Platform with Rotational Cutting

Investigation on rock breaking and optimum spacing of TBM cutters under confining stress using a continuum-discontinuum method

Numerical simulation and experimental studies of rock-breaking methods for pre-grooving-assisted disc cutter

Experimental and numerical investigations on the force characteristics of cutter in different regions of the TBM cutterhead

Experimental Study on Partial Wear of TBM Disc Cutter

Study of Rock-Cutting Process by Disc Cutters in Mixed Ground based on Three-dimensional Particle Flow Model

Rock Adaptability of TBM Variable Cross-section Cutter Ring Based on Finite Element Simulation

Experimental Investigation on the Influence Factors on TBM Cutter Wear Based on Composite Abrasion Test

Rock Crushing Analysis of TBM Disc Cutter Assisted by Ultra-High-Frequency Loading

Numerical study on the rock breaking mechanism of high-pressure water jet-assisted TBM digging technique based on 2D-DEM modelling

Full-scale Test of Disc Cutter Rotary Cutting in TBM Tunnelling: a Case Study of Mawan Granite in Shenzhen, China

Influence of Penetration on the Rock-Breaking Efficiency of a TBM Cutter

Spacing Optimization of the TBM Disc Cutter Rock Fragmentation, Based on the Energy Entropy Method