Abstract:Convective drying of wastewater sludges and sawdust/sludge mixtures was studied. The first part of this work was an experimental study performed in a cross-flow convective dryer using 500 g of wet material extruded through a disk with circular dies of 12 mm. The results showed that the sawdust addition has a positive impact on the drying process from a mass ratio of 2/8, on a dry basis, with observed drying rates higher than the original sludge. The second part of this work consisted of developing a drying model in order to identify the internal diffusion coefficient and convective mass transfer coefficient from the experimental data. A comparison was made between fitted drying curves, well represented by the Newton's model, and the analytical solutions of the diffusion equation applied to a finite cylinder. Variations of dimensional characteristics, such as the volume and exchange surface of the sample bed, were obtained by X-ray tomography. This technique allowed us to confirm that shrinkage, which is an important phenomenon occurring during sludge and sawdust/sludge mixture drying, must be taken into account. The results showed that both the internal diffusion coefficient and convective mass transfer coefficient were affected by mixing and sawdust addition. The internal diffusion coefficient changed from 7.77 × 10−9 m2/s for the original sludge to 7.01 × 10−9 m2/s for the mixed sludge and then increased to 8.35 × 10−9 m2/s for the mixture of a mass ratio of 4/6. The convective mass transfer coefficient changed from 9.70 × 10−8 m/s for the original sludge to 8.67 × 10−8 m/s for the mixed sludge and then increased to 12.09 × 10−8 m/s for the mixture of a mass ratio of 4/6. These results confirmed that sawdust addition was beneficial to the sludge drying process as the mass transfer efficiency between the air and material increased. Reinforcing the texture of sludge by adding sawdust can increase the drying rate and decrease the drying time, and then the heat energy supply will be reduced significantly. The study also showed that neglecting shrinkage phenomenon resulted in an overestimation for the internal diffusion coefficient for the convective drying of sludges and sawdust/sludge mixtures.

Experimental and Theoretical Research on Agitated Contact Drying of Sewage Sludge in a Continuous Paddle Dryer

Research on Sludge Drying Characteristics in a Double-Axis Paddle Dryer by Coupling Markov Chain and Penetration Theory

Experimental and Theoretical Study of Agitated Contact Drying of Sewage Sludge under Partial Vacuum Conditions

Measurement and Simulation of the Contact Drying of Sewage Sludge in a Nara-type Paddle Dryer

Measurement and Modelling of Moisture Distribution and Water Binding Energy of Dredged Sludge

Comparative Study on Drying Characteristics of Sewage Sludge in Two Kinds of Indirect Heat Drying Equipment

Two-Dimensional Modelling of Sludge Heat and Mass Transfer in a Paddle Dryer

Emission and Drying Kinetics of Paper Mill Sludge During Contact Drying Process

Two dimensional modeling of sewage sludge flow in a double-axis continuous paddle dryer

Theoretical and experimental research on heat and mass transfer in a turbine thin layer dryer

Methods, mechanisms, models and tail gas emissions of convective drying in sludge: A review

Experimental research on thermal drying and combustion characteristics of sludge

Enhancement of conductive drying of sewage sludge with mechanical compression: Drying kinetics, and interfacial heat transfer behavior

Convective drying behavior of sawdust-sludge mixtures in a fixed bed

Analysis of the Shrinkage Effect on Mass Transfer During Convective Drying of Sawdust/Sludge Mixtures

Experimental and modeling study of the long cylindrical oily sludge drying process

Emission Characteristics and Formation Mechanism Analysis of Exhaust during Sludge Thermal Drying Process

Numerical Investigation on Thermal Drying Process of Sludges Based on CFD-DEM

Drying properties and kinetics of MVR technology applied to the hollow blade dryer drying sludge

Study on the Kinetics of Shell Powder Intensified Drying Process of Sludge

Mechanical compression assisted conductive drying of thin-film dewatered sewage sludge: Process performance, heat and mass transfer behavior