Abstract:The underground energy geostructure represented by the energy pile is one of the key paths for the cooperative development of underground space and geothermal energy. Because of its advantages of low cost, high efficiency and no extra occupation of underground space, it has become a feasible alternative to the borehole heat exchanger. The change in the temperature field of the energy pile and its surrounding ground not only affects the geological environment but also influences the thermomechanical performance and the durability of the structure. However, the temporal and spatial unsteady-state temperature distribution of piles and surrounding rock under typical intermittent and unbalanced thermal load conditions is still unclear. In this paper, a finite element model was applied to analyze the unsteady-state temperature distribution, and the thermomechanical behavior of the energy pile group was developed and verified. The temperature field distribution of pile and surrounding rock under typical intermittent working and unbalanced thermal load conditions were determined. Moreover, the thermomechanical behavior characteristics of the energy pile group were investigated. Finally, the influences of pile layout on the thermomechanical behavior of the energy pile group were identified by designing six different scenarios. The results indicate that under typical intermittent operation conditions, the temperature of the energy pile and surrounding ground near the heat exchange pipe varies periodically. For areas with unbalanced cooling and heating loads, long-term operation of energy piles leads to thermal accumulation, and the maximum temperature of energy piles occurs in the first daily cycle. In summer/winter working conditions, the increase/decrease in pile temperature induces axial compression/tensile stress. When the pile group is partially used as the energy pile, the non-energy pile acts as the “anchor pile”, and it generates the added tensile stress.

Model Tests of Energy Piles with and Without A Vertical Load

Model Tests on Elevated Piles Subjected to Lateral Static and Impact Loading

Model Test on Bearing Characteristic of Static Drill Rooted Energy Pile

Model Tests on the Bearing Capacity of Precast Open-Ended Micro Pipe Piles in Soft Soil

Model tests on the bearing capacity of precast oxen-ended micro pipe plies in sort soil

Centrifuge Modelling of Lateral Loading Behaviour of a “Semi-Rigid” Mono-pile in Soft Clay

Centrifuge Model Tests on Laterally Loaded Piles in Sand

Vertical dynamic responses of model energy piles

Performance of horizontally loaded energy piles in saturated clay

Performance of laterally loaded H-piles in sand

Model tests on characteristics of ocean and offshore elevated piles with large lateral deflection

FEM Analysis and Simplified Approach for a Single Energy Pile Subjected to Thermomechanical Loads

Influence of Thermal Loading on Bearing Capacity of Geothermal Energy Piles

A New Method for Analyzing the Thermomechanical Behavior and the Null Point Movement of Energy Piles

Thermo-mechanical behavior of driven energy piles from full-scale load tests

A Finite Element Model for Investigating Unsteady-State Temperature Distribution and Thermomechanical Behavior of Underground Energy Piles

An In-Situ Experimental Investigate of Thermo-Mechanical Behavior of a Large Diameter over Length Energy Pile

Model Test on Load Transfer Mechanism of a Static Drill Rooted Nodular Pile

Bearing Performance of Geothermal Energy Pile Subjected to Thermal Loading

Model test study on horizontal bearing behavior of pile under existing vertical load

Model Tests on Jacking Installation and Lateral Loading Performance of Jacket Foundation in Sand