Abstract:The conversion of reactants, reaction rate referred to catalyst mass, and turnover frequency (TOF) are values typically employed to compare the activity of different catalysts. However, experimental parameters have to be chosen carefully when systems of different complexity are compared. In order to characterize UHV-based model systems, we use a highly sensitive sniffer setup which allows us to investigate the catalytic activity by combining three different measurement modes: temperature-programmed desorption, continuous flow, and pulsed-reactivity experiments. In this article, we explore the caveats of quantifying catalytic activity in UHV on the well-studied and highly defined reference system of CO oxidation on Pt(111), which we later compare to the same reaction on Pt 19 clusters deposited on Fe 3 O 4 (001). We demonstrate that we can apply fast heating ramps for TOF quantification, thus inducing as little sintering as possible in the metastable clusters. By changing the reactant ratio, we find transient reactivity effects that influence the TOF, which should be kept in mind when comparing catalysts. In addition, the TOF also depends on the surface coverage that itself is a function of temperature and pressure. At a constant reactant ratio, in the absence of transient effects, however, the TOF scales linearly with total pressure over the entire measured temperature range from 200 to 700 K since the reaction rate is dependent on both reactant partial pressures with temperature-dependent reaction order. When comparing the maximum TOF at this particular reactant ratio, we find a 1.6 times higher maximum TOF for Pt 19 /Fe 3 O 4 (001) than for Pt(111). In addition, pulsed-reactivity measurements help identify purely reaction-limited regimes and allow for a more detailed investigation of limiting reactants over the whole temperature range.

Determining Number of Active Sites and Tof for the High-Temperature Water Gas Shift Reaction by Iron Oxide-Based Catalysts

A perspective on chromium-Free iron oxide-based catalysts for high temperature water-gas shift reaction

Dual Metal Active Sites in an Ir 1 /feo X Single‐Atom Catalyst: A Redox Mechanism for the Water‐Gas Shift Reaction

Identification of Relevant Active Sites and A Mechanism Study for Reverse Water Gas Shift Reaction over Pt/Ceo2 Catalysts

Unraveling Active Sites Regulation and Temperature-Dependent Thermodynamic Mechanism in Photothermocatalytic CO2 Conversion with H2O

Reactive Pt-TiN interfacial sites for H 2 O activation and the low-temperature water gas shift

Auδ−–Ov–Ti3+ Interfacial Site: Catalytic Active Center Toward Low-Temperature Water Gas Shift Reaction

Hydrogen Production by Water-Gas Shift Reaction over Co-promoted MoS2/Al2O3 Catalyst: the Intrinsic Activities of Co-promoted and Unprompted Sites

Identification of the Active Cu Phase in the Water−Gas Shift Reaction over Cu/ZrO2 from First Principles

Visualization of the Active Sites of Zinc-Chromium Oxides and the CO/H2 Activation Mechanism in Direct Syngas Conversion

Single Atomic Pt on SrTiO3 Catalyst in Reverse Water Gas Shift Reactions

Water Gas Shift Reaction Activity on Fe (110): A DFT Study

Probing active sites for carbon oxides hydrogenation on Cu/TiO2 using infrared spectroscopy

Coordination-number-determined activity of copper catalyst in water-gas shift reaction

Identification of the Active Cu Phase in the Water−Gas Shift Reaction over Cu/ZrO<sub>2</sub>from First Principles

In situ Mössbauer Spectroscopy Study of the Activation and Reducibility of Chromium- and Aluminium-doped Iron Oxide based Water-Gas Shift Catalysts under Industrially Relevant Conditions

A Critical View on the Quantification of Model Catalyst Activity

Towards the Rational Design of Pt-based Alloy Catalysts for the Low-Temperature Water-Gas Shift Reaction: from Extended Surfaces to Single Atom Alloys

Water-Gas-Shift Reaction on Au/TiO2–x Catalysts with Various TiO2 Crystalline Phases: A Theoretical and Experimental Study

Cu Modified SrTiO3 Perovskites Toward Enhanced Water Gas Shift Catalysis: A Combined Experimental and Computational Study

Synergistic effect of Cu+ single atoms and Cu nanoparticles supported on alumina boosting water-gas shift reaction