Abstract:Abstract To ensure a reliable power supply with a minimum environmental impact in the future, further increases in efficiency and flexibility of fossil-fired power plants are major challenges to address in recent R&D activities. In order to counterbalance substantial fluctuations in the electricity grid due to the rising share of renewable resources, frequent start-ups and shut-downs of turbomachinery will be claimed by the market. Hence, along with the development of advanced materials for elevated steam parameters, contemplations with respect to altered boundary conditions of established materials, e.g., for bolted pipe flange connections, are required. In this paper, a selection of results from a recently finished research work on stress relaxation will be presented. Together with European power plant component manufacturers, a newly developed test rig comprising a scaled intermediate pressure (IP) steam turbine pipe flange now allows investigations under near-service conditions. Before, throughout, and after performance of the experiments, an extensive measurement setup enables the examination of effects that cannot be studied in standardized relaxation tests. Within this work, a loss in bolt pretension of up to almost 50% over a comparatively short period of experimental time was observed. By means of numerical calculations, creep deformation in the transition areas between pipe and flange plate sections was identified to be a major originator of these pretension drops. Particularly, good correlations between experiments and finite element method (FEM) simulations could be achieved through the implementation of enhancements concerning the fitting strategy of the Graham–Walles-type creep model which was used.

Creep Behavior of Metal-To-Metal Contact Bolted Flanged Joint

Behavior of bolted joints with metal-to-metal contact type gaskets under bolting-up and loading conditions

Experimental and Numerical Characterization of Low Cycle Fatigue and Creep Fatigue Behaviour of P92 Steel Welded Joint

Research on Fatigue-Creep Interaction Damage of Steel 1.25Cr0.5mo

On Creep Fatigue Interaction of Components at Elevated Temperature

Remaining creep properties and fracture behaviour of P92 steel welded joint under prior low cycle fatigue loading

Effect of External Bending Moment and Creep on Sealing Behavior of Bolted Flanged Connections

EXPERIMENTAL STUDY OF THE BEARING CAPACITY OF INTERNAL|EXTERNAL FLANGE JOINTS SUBJECTED TO PRESSURE AND BENDING LOADINGS WITH VARIOUS ECCENTRICITIES

An Insight into the Creep-Fatigue Damage Localization in Welded Joints Based on Crystal Plasticity Finite Element Method

Numerical investigation on the creep damage induced by void growth in heat affected zone of weldments

Characterization of the Cyclic Softening and Remaining Creep Behaviour of P92 Steel Weldment

Creep Behaviors Calculated by Varying Material Constants Obtained from Different Stress Regions for a Closed-End P91 Pipe

The correlation between prior fatigue damage and remaining creep properties in a high chromium steel welded joint

Numerical Simulation of Void Growth Induced Creep Rupture in HAZ at Elevated Temperature

On the Creep Fatigue Behavior of Metal Matrix Composites

Analytical Method of Gasket Stress on Bolted Flanged Connections in Consideration of External Bending Moments and Elements Creep

Creep of Stainless Steel under Heat Flux Cyclic Loading (500-1000 Degrees C) with Different Mechanical Preloads in a Vacuum Environment Using 3D-DIC

Prediction of Time-Correlated Leakage Rates of Bolted Flanged Connections by Considering the Maximum Gasket Contact Stress

Influence of creep on preload relaxation of bolted composite joints: Modeling and numerical simulation

Component Testing and Numerical Calculation of a Bolted High Temperature Power Plant Pipe Flange Under Complex, Near-Service Loads

A new creep damage assessment method for metallic material under variable load conditions at elevated temperature