Abstract:Innovative clean label processes employed in the manufacture of acid gels are targeted to modify the structure of proteins that contribute to rheological properties. In the present study, CO2-treated milk protein concentrate powder with 80% protein in dry matter (TMPC80) was mixed with nonfat dry milk (NDM) in different ratios for the manufacture of acid gels. Dispersions of NDM and TMPC80 that provided 100, 90, 70, and 40% of protein from NDM were reconstituted to 4.0% (wt/wt) protein and 12.0% (wt/wt) total solids. Dispersions were adjusted to pH 6.5, followed by heat treatment at 90°C for 10 min. Glucono-δ-lactone was added and samples were incubated at 30°C, reaching pH 4.5 ± 0.05 after 4 h of incubation. Glucono-δ-lactone levels were adjusted to compensate for the lower buffering capacity of samples with higher proportions of TMPC80, which is attributable to the depletion of buffering minerals from both the serum and micellar phase during preparation of TMPC80. Sodium dodecyl sulfate-PAGE analysis indicated a higher amount of caseins in the supernatant of unheated suspensions with increasing proportions of CO2-treated TMPC80, attributable to the partial disruption of casein micelles in TMPC80. Heat treatment reduced the level of whey proteins in the supernatant due to the heat-induced association of whey proteins with casein micelles, the extent of which was larger in samples containing more micellar casein (i.e., samples with a lower proportion of TMPC80). Particle size analysis showed only small differences between nonheated and heated dispersions. Gelation pH increased from ˜5.1 to ˜5.3, and the storage modulus of the gels at pH 4.5 increased from ˜300 to ˜420 Pa when the proportion of protein contributed by TMPC80 increased from 0 to 60%. Water-holding capacity also increased and gel porosity decreased with increasing proportion of protein contributed by TMPC80. The observed gel properties were in line with microstructural observations by confocal microscopy, wherein sample gels containing increasing levels of TMPC80 exhibited smaller, well-connected aggregates with uniform, homogeneous pore sizes. We concluded that TMPC80 can be used to partially replace NDM as a protein source to improve rheological and water-holding properties in acid gels. The resultant gels also exhibited decreased buffering, which can improve the productive capacity of yogurt manufacturing plants. Overall, the process can be leveraged to reduce the amount of hydrocolloids added to improve yogurt consistency and water-holding capacity, thus providing a path to meet consumer expectations of clean label products.

Fabrication of Novel Casein Gel with Controlled Release Property Via Acidification, Spray Drying and Tableting Approach.

Novel Complex Hydrogels Based on N-carboxyethyl Chitosan and Quaternized Chitosan and Their Controlled in Vitro Protein Release Property.

Novel Casein Hydrogels: Formation, Structure and Controlled Drug Release

Controlled Release of Caffeine from Tablets of Spray-Dried Casein Gels

Smart Release-Control of Microencapsulated Ingredients from Milk Protein Tablets Using Spray Drying and Heating

Preparation of Novel Cross-Linked and Octylated Caseinates Using a Biphasic Enzymatic Procedure and Their Functional Properties.

Influence of partially demineralized milk proteins on rheological properties and microstructure of acid gels

Laccase and Glucono-Δ-lactone Dual-Induced Gelation of Casein and Arabinoxylan: Microstructures, Physicochemical Properties, and Ph-Responsive Release Behavior

Synthesis of casein-γ-polyglutamic acid hydrogels by microbial transglutaminase-mediated gelation for controlled release of drugs

Physicochemical characterization and enzymatic degradation of casein microcapsules prepared by aqueous coacervation

Pre-gelation Assisted Spray Drying of Whey Protein Isolates (WPI) for Microencapsulation and Controlled Release

Controllable Viscoelastic Properties of Whey Protein-Based Emulsion Gels by Combined Cross-Linking with Calcium Ions and Cinnamaldehyde

Spray Drying of Casein Aggregates Loaded with β-Carotene: Influences of Acidic Conditions and Storage Time on Surface Structure and Encapsulation Efficiencies

Optimization of Deamidation of Casein by Protein-Glutaminase and Its Effect on Structural and Functional Properties

Modulating the aggregation behaviour to restore the mechanical response of acid induced mixed gels of sodium caseinate and soy proteins

Formation and structural properties of acid-induced casein–agar double networks: Role of gelation sequence

Improving the Textural Properties of Camel Milk Acid Gel by Treatment with Trisodium Citrate and Transglutaminase

Acid-Induced Gelation of Enzymatically and Nonenzymatically Cross-Linked Caseins-Texture Properties, and Microstructural Insights

Properties of acid gels made from sodium caseinate-maltodextrin conjugates prepared by a wet heating method

A novel microgel and associated post-fabrication encapsulation technique of proteins

Casein Gel Particles As Novel Soft Pickering Stabilizers: the Emulsifying Property and Packing Behaviour at the Oil-Water Interface