Abstract:In this study, a thermo-mechanical finite element model was developed to investigate the thermal deformation during a stamping process of an automotive body part. The stamping process was decomposed into the 6 sub-steps to reflect the physical boundary conditions found in an actual stamping equipment. The temperature distributions of the actual stamping process were measured by two thermography cameras. The developed numerical procedure was then validated against the measured temperature distributions. Due to the limited accessibility to the actual equipment and high reflectivity of the involved material, the reflectivity index for the thermal imaging device (i.e., emissivity) was experimentally determined. A sample specimen made of the same material with the die material was built. The thermocouples were placed underneath the specimen surface through holes and used to directly measure the surface temperature distribution. The emissivity for the sample specimen was then determined by comparing the temperature measured by the thermocouples to the temperature measured by the thermographic camera. When the lubrication oils were spread on the sample specimen, the emissivity was set to a value 0.7. The thermal images were corrected based on the emissivity experimentally obtained and used to validate the finite element model simulation for the stamping process. With the validated finite element model, the investigation on the variation in the temperature and stress during each sub-step was performed. With the zero thermal expansion rate, the pure thermal effect on the temperature distribution was simulated. The pure thermal deformation in the Blank (i.e., target surface) was similar to the spring back distance after the blank was released from the molds. During the stamping process, the heat generation was obtained due to either friction between surfaces and plastic deformation of the target surface. We found that the plastic deformation played a critical role in the final temperature rise.

Hot Stamping of Patchwork Blanks: Modelling and Experimental Investigation

Modeling Heat Transfer During Friction Stir Welding Using a Meshless Particle Method

Development of Drawing Die for Heat-Shield Panel of Automobile Engine Based on Finite Element

Thermo-mechanical coupled simulation of hot stamping components for process design

FEM model optimization study of mechanical properties and material selection in stamping process

A Tailored Preparation Method of Variable Strength for Ultra-High-Strength Steel Sheet and Mapping Mechanism between Process and Property

Experimental and Numerical Study on Failure Behaviors of Composite Grid Stiffeners under Tensile and Flexural Loading

Numerical modeling of the thermal deformation during stamping process of an automotive body part

A three-dimensional viscoelastic analysis of thermoplastic resin matrix composite laminates during hot stamping

Hot Stamping of a B-Pillar Reinforced Panel With 7075 Aluminum Alloy and the Feasibility Study of Short-Time Aging

Parameter Optimization of Hot Stamping for an Extension Part Based on DYNAFORM under the Background of New Engineering

A dual‐scale three‐dimensional thermo‐viscoelastic model for the hot stamping simulation of thermoplastic composites

Machine learning in the prediction of formability in aluminum hot stamping process with multiple variable blank holder force

A New Wear Calculation Method for Galvanized Ultra-High-Strength Steel during Hot Stamping

Study on the Effect of Heat Treatment on Microstructures and High Temperature Mechanical Properties of Welding Spots of Hot Stamped Ultra-High Strength Steel Patchwork Blanks

Die Structure Analysis Of Stress Distribution During High-Strength Steel Stamping Process And Experimental Validation

Fracture Behavior of the Hot-Stamped PHS2000 Steel Based on GISSMO Failure Model

Structure Design on Thermoplastic Composites Considering Forming Effects

Cloud FEA of hot stamping processes using a software agnostic platform

Investigating Welding Distortion of Thin-Plate Stiffened Panel Steel Structures by Means of Thermal Elastic Plastic Finite Element Method

Design optimization and application of hot-stamped B pillar with local patchwork blanks