Abstract:Next generation cosmic microwave background (CMB) polarimetry experiments aim to deploy order 500,000 detectors, requiring repeatable and reliable fabrication process with stable and uniform transition edge sensor (TES) bolometer performance. We present a hafnium (Hf)-based TES bolometer for CMB experiments. We employ a novel heated sputter deposition of the Hf films enabling us to finely tune the critical temperature (Tc) between 140 mK - 210 mK. We found elevated deposition temperatures result in films with lower stress, larger crystal sizes, and a smaller relative abundance of the m-plane to c-plane $\alpha$ phase, all contributing to the empirical linear dependence of critical temperature on deposition temperature. Crucially, the heated sputter deposition simultaneously ensures that the critical temperature does not drift despite exposure to heat throughout ongoing fab processes (sometimes reaching 350C) as long as the initial deposition temperature is not exceeded. Tcs lower than 170 mK require deposition temperature greater than 400C, far in excess of typical temperatures the wafer may experience. This ample thermal budget allows us to relax the stringent thermal management that conventional aluminum manganese (AlMn) TES bolometers require, for which temperatures as low as 200C - 250C are used to anneal the AlMn in an effort to adjust the Tc. Hf additionally exhibits an intrinsic steep superconducting transition (we measure $\alpha >$ 200) and a corresponding high loop gain (exceeding $\mathcal{L}>10$ deep in the transition). We precisely design the normal resistance of the TES to range between 10 milli-Ohm and 1 Ohm through an interdigitated geometry, making these TES bolometers compatible with both TDM, FDM, and $\mu$-mux readout systems. We report on bolometer parameters including critical temperature, normal resistance, saturation power, time constant, and loop gain.

Fabrication and Characterization of Superconducting Bilayer (Al/Ti) Transition-Edge Sensor Bolometer Array

Modelling of Freestanding Membrane-Supported Superconducting Al/Ti Bilayer Transition Edge Sensor Bolometer

Design and Fabrication of Superconducting Transition Edge Sensor Bolometers with Background Limited Noise Performance

Design, Fabrication, and Characterization of Ti/Au Transition-Edge Sensor with Different Dimensions of Suspended Beams

Design and characterization of a 90 GHz CMB TES bolometer

Fabrication and Characterization of Al-Mn Superconducting Films for Applications in TES Bolometers*

A Study of Al-Mn Transition Edge Sensor Engineering for Stability

Development of hafnium-based transition edge sensor bolometers for cosmic microwave background polarimetry experiments

Superconductivity of Bilayer Titanium/indium Thin Film Grown on SiO 2 /Si（001）

Design, fabrication and characterization of Ti/Au TES with different dimensions of suspended beams

Optical response of Al/Ti bilayer transition edge sensors

Characterization and Improvement of the Thermal Stability of TES Bolometers

Electrothermal Properties Characterization of Transition Edge Sensor Bolometers Based on R-T Tests

Investigation of the Superconducting Ti/PdAu Bilayer Films for Transition Edge Sensors

Investigation of Superconducting Titanium Films for Transition Edge Sensors

Properties of Low TC AlMn TES

Thermal Annealing of AlMn Transition Edge Sensors for Optimization in Cosmic Microwave Background Experiments

Thin Film Like Terahertz Bolometric Detector on Bi2212 Single Crystal

Assessing the Aging Effect on Ti/Au Bilayers for Transition-Edge Sensor (TES) Detectors

Wide-Range Bolometer with RF Readout TES

Study of Long-Term Stability of Mo–Cu Bilayer Films