Abstract:Due to the influence of the connection distance between the mutual inductor primary circuit and the metering device secondary circuit, the detection induced current of the traditional method is extremely small, which cannot accurately detect the authentic situation of the wiring, resulting in long detection time and low detection accuracy. Therefore, this paper proposes the automatic detection method of the secondary circuit connection of the metering device mutual inductor. Through the voltage sampling circuit, the secondary circuit measurement data are obtained. Using the pulse signal shaping function and the ADE7753 chip to process the secondary circuit measurement data, the secondary circuit connection fault judgment is determined. According to the judgment, the electric energy meter is used, combined with the secondary circuit measurement data, and the automatic detection of the secondary circuit connection is achieved by calculation. The experimental results show that compared with the traditional detection method, the automatic detection method of the secondary circuit connection of the metering device mutual inductor designed in this paper achieves normal and stable detection induction current. There is no inductive current with an extremely small condition, the detection accuracy is high, and the detection time is short, indicating that the method is suitable for application in actual detection projects.

A new detecting method of break in secondary circuit of current transformer in micro-based differential protection of power transformer

Detection Method for Current Transformer Saturation Based on the Dropping of the Secondary Current

The Principle of Transformer Differential Protection Based on Wave Comparison

A New Method to Identify Inrush Current Based on HHT

A NEW METHOD TO IDENTIFY INRUSH CURRENT BY PHASOR COMPARISON

An Innovative Method to Achieve Minimum Tripping Current Conformity for Type A RCCBs

A Novel Method for Current Transformer Saturation Countermeasure Based on Comparing Two Currents' Polarities

Identification of Cross-Country Fault of Power Transformer for Fast Unblocking of Differential Protection

Transformer Differential Protection Method for Recognition between Power Transformer Internal Defects and Inrush Current: A Comprehensive Review of Detection Techniques

A New Method to Identify Inrush Current Based on Error Estimation

An NPE-PCA-based Detection Method of Distribution Transformer Closing Surge Waveform

Research on automatic detection method of secondary circuit connection of the measuring device mutual inductor

An online diagnosis method for the inter-turn fault of current transformer based on ΔI-E curves

Modeling Method of High-frequency Equivalent Circuit of Current Transformer for Overvoltage Detection

On-site Application of Partial Discharge Detection of Transformer Using Very Wide Bandwidth Pulse Current Method

Principle of leakage current protection based on residual current variation and its application

Research on AC and DC leakage detection technology based on fluxgate principle

Introduction of an intriguing approach for eletric current transformer on-site examining repairing

ANALYSIS AND COUNTERMEASURE FOR MISOPERATION OF LONGITUDINAL DIFFERENTIAL PROTECTION WITH UNCLEAR REASON

A New Method to Detect the Short Circuit Current in DC Supply System Based on the Flexible Rogowski Coil

Intelligent Detection Technology and Engineering Application of High Voltage Circuit Breaker Based on One Key Detection