Abstract:Effects of openings on postbuckling behavior of large‐size composite C‐beam. Proper design and accurate mechanical assessment of composite C‐beam after opening are of great importance in structure engineering. This paper aims to experimentally and analytically investigate the postbuckling response of large‐size C‐beam with web opening under bending‐shear coupling load. New specimen with four different open shapes were designed and tested. Strain gauges and displacement measurements were applied to monitor its buckling behavior, strain field distribution and critical failure load. Four specimens with various openings were loaded until catastrophic failure occurred. Additionally, an analytical model was introduced to predict the residual strength of circular opening. The results indicate that while the presence of an opening significantly decreases the load carrying capacity, it has minimal effect on the bending stiffness. Compared with intact specimen, the initial delamination, buckling and ultimate strength of the circular opening decreases less than those of the rectangular opening. By altering the position of the rectangular opening, improvements can be made in terms of initial delamination resistance and buckling load; however, ultimate strength remains largely unaffected. Reinforcing the edge of an opening further reduces resistance to initial delamination but other two indicators are improved. Overall, from buckling to failure stages, post‐buckling bearing capacity after opening decreases by 40%. Moreover, the shear failure mode is observed during catastrophic failures. And the analysis method employed is relatively conservative. Highlights Ten large size composite C beams are conducted under coupling loads. Deformation, strain distribution and failure mode are presented. Influence of openings on postbuckling behavior of beam is analyzed. An analysis method is employed to predict the residual strength of beam. It could provide valuable insights for assisting in designing beam openings.

Study on the effects of initial imperfections on stability bearing capacity of the web opening C-shaped cold-formed steel beam

Finite element analysis on shear capacity of the corrugated web H-shaped steel beam

Case Study on Stability Performance of Asymmetric Steel Arch Bridge with Inclined Arch Ribs

Stability analysis method for lattice shells accounting for buckling of members

Elastic Local Buckling and Width-to-Thickness Limits of I-Beams Incorporating Flange–Web Interactions

A RESTUDY ON STABILITY OF STEEL BEAMS:INTERNATIONAL TESTS AND THEORETICAL ANALYSES(Ⅱ)

A RESTUDY ON STABILITY OF STEEL BEAMS:HISTORICAL EVOLVEMENT AND DEFICIENCIES OF CHINESE CODE (Ⅰ)

EFFECT OF INITIAL IMPERFECTIONS ON OVERALL BUCKLING BEHAVIOR OF HIGH STRENGTH STEEL COLUMNS

FEM Analysis on Bearing Capacity of Cold-formed Thin-walled Steel Beam with C-shaped Section Openings

Advances in Buckling Analysis of Axial Compression Loaded Thin-walled Cylindrical Shells Based on Initial Imperfection Sensitivity

Progressive collapse analysis of beam–column substructures considering various reduced beam web sections

Probabilistic study and numerical modelling of initial geometric imperfections for 3D steel frames in advanced structural analysis

A study on the stability bearing capacity of fastener-style tubular steel formwork-supports

Buckling Behavior Analysis of Thin-Walled Cylindrical Shell Structure under Localized Axial Compression Load Based on Initial Imperfection Sensitivity

LOCAL BUCKLING OF THIN-WALLED HIGH STRENGTH STEEL COLUMNS WITH WEB STIFFENERS

Effect of Local Geometric Imperfections on Axial Buckling of Welded Steel Tanks

Effects of openings on postbuckling behavior of large‐size composite C‐beam under bending‐shear coupling load

EFFECT OF INITIAL IMPERFECTION ON MECHANICAL PROPERTY OF STUB COLUMNS OF SQUARE CONCRETE-FILLED THIN-WALLED STEEL TUBES

Behaviour of Steel I Beams with Web Openings

Finite Element Analysis on Bearing Behavior of I-section Beam with Longitudinally Variable Thickness Flanges

Analysis of Welding Heat Effect on Load-Carrying Behavior of I Section Steel Beam-Columns Strengthened by Welding