Precise Controllable Post-sulfonation for Preparation of Sulfonated Poly (arylene ether sulfone)s and Their Properties for Proton Exchange Membrane

Xiao Lei,Zhang Chen,He Meiyu,Chen Kangcheng

DOI: https://doi.org/10.7503/cjcu20170842

2018-01-01

Abstract:A series of poly (arylene ether sulfone)s with high molecular weight was prepared from 4-fluorophenyl sulfone, 4, 4'-biphenol and bis (4-hydroxyphenyl) sulfone with different mole ratio. Due to the large difference between the electronic effects of biphenyl fragment and phenyl sulfone fragment on the polymer, the sulfonation reaction is easily carried out on biphenyl fragments with higher electron cloud density. The sulfonic acid groups were introduced to ortho-position of the oxy ether group on the biphenyl and sulfonation degree were successfully predicted after post-sulfonation process. Sulfonated polylarylene ether sulfone (SPAES) based proton exchange membranes (PEM) were prepared by solution casting method , of which relative viscosity , ion exchange capacity (IEC) , water uptake and swell ratio , proton conductivity , oxidative stability , mechanical properties and cell performance were investigated. Relative viscosity of sulfonated copolymers was higher than 1. 2 dL/g. The sulfonated copolymers showed that titration and 'H nuclear magnetic resonance calculated value of IEC were accordingly to that of theoretical. Water uptake and swell ratio obviously increased with increasing of IEC and temperature, and the size change ratio of the thickness direction was larger than that of plane direction in the membranes. The thermal gravimetric analyse (TGA) results indicated that the PEMs have the decompose temperature at about 280 degrees C . All the PEMs showed maximum tensile strength above 50 MPa, and the elongation at break over 15% at 20 degrees C and 20% RH. Free radical oxidative stability test showed the PEMs with low IEC become brittle in Fenton' s reagent over 200 h at 20 degrees C. The proton conductivity of PEMs were increased rapidly with the increase of the IEC and temperature, for example, the conductivity of M2-SPAES(1.34 mmol/g) and M4-SPAES(1.60 mmol/g) were 68 and 89 mS/ cm at 60 degrees C in water, and 99 and 129 mS/cm at 80 degrees C in water, respectively. H-2/O-2 Fuel cell performance showed that the open circuit voltage and maximum power output were higher than 1.0 V and 0.54 W/cm(2) under 60 degrees C , 80% RH and 0.1 MPa back pressure, respectively.