Abstract:Within the pressure range of 9–28 MPa, mass velocity range of 600–1 200 kg/(m 2 ·s), and heat flux range of 200–500 kW/m 2 , experiments were performed to investigate the heat transfer to water in the inclned upward internally ribbed tube with an inclined angle of 19.5 degrees, a maximum outer diameter of 38.1 mm, and a thickness of 7.5 mm. Based on the experiments, it was found that heat transfer enhancement of the internally ribbed tube could postpone departure from nucleate boiling at the sub-critical pressure. However, the heat transfer enhancement decreased near the critical pressure. At supercritical pressure, the temperature difference between the wall and the fluid increased near the pseudo-critical temperature, but the increase of wall temperature was less than that of departure from nucleate boiling at sub-critical pressure. When pressure is closer to the critical pressure, the temperature difference between the wall and the fluid increased greatly near the pseudo-critical temperature. Heat transfer to supercritical water in the inclined upward internally ribbed tube was enhanced or deteriorated near the pseudo-critical temperature with the variety of ratio between the mass velocity and the heat flux. Because the rotational flow of the internal groove reduced the effect of natural convection, the internal wall temperature of internally ribbed tube uniformly distributed along the circumference. The maximum internal wall temperature difference of the tube along the circumference was only 10 degrees when the fluid enthalpy exceeded 2 000 J/g. Considering the effect of acute variety of the fluid property on heat transfer, the coreelation of heat transfer coefficient on the top of the internally ribbed tube was provided.

Rules Governing Temperature Variations of Water Walls with Rifled Tubes in Once Through Boilers during Gliding Pressure Operation

WALL TEMPERATURE CHARACTERISTICS IN A VERTICAL UPWARD INTERNALLY RIBBED TUBE FOR SUPERCRITICAL SLIDING-PRESSURE OPERATION

A Study of Frictional Flow Resistanse within Internally Ribbed Tubes under Supercritical Pressure

Heat Transfer and Frictional Resistance Characteristics of the Water Wall Tube of an Ultra-Supercritical CFB Boiler

Experimental Investigation on Heat Transfer and Frictional Characteristics of Vertical Upward Rifled Tube in Supercritical Cfb Boiler

A Study of Frictional Resistance Characteristics of High-pressure Steam-water Two-phase Flows

Experimental investigation on heat transfer characteristics of low mass﹣flux rifled tube for supercritical pressure boiler with annular furnace

An investigation into the heat transfer characteristics of spiral wall with internal rib in a supercritical sliding-pressure operation once-through boiler

The Experimental Investigation on Flow and Heat Transfer Characteristics of the Rifled Water Wall Tube of an Ultra-supercritical CFB Boiler

INVESTIGATION ON FRICTIONAL RESISTANCE IN INTERNALLY RIBBED TUBES OF A 600 MW SUPERCRITICAL PRESSURE BOILER

Heat Transfer Characteristics of Spiral Water Wall Tube in a 1000 MW Ultra-Supercritical Boiler with Wide Operating Load Mode

Flow Distribution Characteristics of Intermediate Headers of a Supercritical Once-through Boiler's Water Cooled Walls, Operating Under Variable Pressure Conditions

Experimental Investigation On Heat Transfer And Frictional Characteristics Of Vertical Upward Rifled Tube In The Advanced Ultra Supercritical Steam Generator

Experimental Investigation on Heat Transfer Characteristics of Smooth Water Wall Tube of an Ultra-Supercritical CFB Boiler

An Experimental Study on Distribution Characteristics of High Pressure Steam-Water Two-Phase Flow

Numerical Calculation on Temperature Fields of Vertical Waterwall in Ultra-supercritical Boilers

Investigation on Flow Distribution Characteristics of a Supercritical Pressure Once-through Boiler

BOILING HEAT TRANSFER AND FRICTIONAL PRESSURE DROP IN INTERNALLY REBBED TUBES AT HIGH PRESSURES

ICOPE-15-C136 Study on Temperature Characteristics of Water Wall in 700℃ Ultra Supercritical Boiler

Tube-Wall Temperature Prediction of a 660-MW Ultra-Supercritical Double-Reheat Boiler under Flexible Peak Shaving

Experimental Research on Wall Temperature Distribution and Heat Transfer Characteristics of the Tilted Smooth Riser Tubes in the Supercritical Pressure Region