High-Conductivity Argyrodite Li6PS5Cl Solid Electrolytes Prepared Via Optimized Sintering Processes for All-Solid-State Lithium-Sulfur Batteries

Shuo Wang,Yibo Zhang,Xue Zhang,Ting Liu,Yuan-Hua Lin,Yang Shen,Liangliang Li,Ce-Wen Nan
DOI: https://doi.org/10.1021/acsami.8b15121
IF: 9.5
2018-01-01
ACS Applied Materials & Interfaces
Abstract:Highly Li-ion conductive Li6PS5Cl solid-state electrolytes (SSEs) were prepared by solid-state sintering method. The influence of sintering temperature and duration on the phase, ionic conductivity, and activation energy of Li6PS5Cl was systematically investigated. The Li6PS5Cl electrolyte with a high ionic conductivity of 3.15 x 10(-3) S cm(-1) at room temperature (RT) was obtained by sintering at 550 degrees C for just 10 min, which was more efficient taking into account such a short preparation time in comparison with other reported methods to synthesize Li6PS5Cl SSEs. All-solid-state lithium sulfur batteries (ASSLSBs) based on the Li6PS5Cl SSE were assembled by using the nano-sulfur/multiwall carbon nanotube composite combined with Li6PS5Cl as the cathode and Li-In alloy as the anode. The cell delivered a high discharge capacity of 1850 mAh g(-1) at RT for the first full cycle at 0.176 mA cm(-2) (similar to 0.1C). The discharge capacity was 1393 mAh g(-1) after 50 cycles. In addition, the Coulombic galvanostatic cycling. The experimental data showed that Li6PS5Cl was a good candidate for efficiency remained nearly 100% during the SSE used in ASSLSBs.
What problem does this paper attempt to address?