Abstract:A high ratio (winding ratio of 1:80) pulse transformer with a modular ferrite core was developed for a repetitive resonant charging system. The magnetic core is constructed from 68 small blocks of ferrites, glued together by epoxy resin. This allows a high degree of freedom in choosing core shape and size. Critical issues related to this modular design are the size tolerance of the individual ferrite blocks, the unavoidable air gap between the blocks, and the saturation of the core. To evaluate the swing of the flux density inside the core during the charging process, an equivalent circuit model was introduced. It was found that when a transformer is used in a resonant charging circuit, the minimal required volume of the magnetic material to keep the core unsaturated depends on the coupling coefficient of the transformer and is independent of the number of turns of the primary winding. Along the flux path, 17 small air gaps are present due to the inevitable joints between the ferrite blocks. The total air gap distance is about 0.67 mm. The primary and secondary windings have 16 turns and 1280 turns, respectively, and the actually obtained ratio is about 1:75.4. A coupling coefficient of 99.6% was obtained. Experimental results are in good agreement with the model, and the modular ferrite core works well. Using this transformer, the high-voltage capacitors can be charged up to more than 70 kV from a low-voltage capacitor with an initial charging voltage of about 965 V. With 26.9 J energy transfer, the increased flux density inside the core was about 0.23 T, and the core remains unsaturated. The energy transfer efficiency from the primary to the secondary was around 92%.

250 Kv 6 Ma Compact Cockcroft-Walton High-Voltage Power Supply

A Novel ZVS High Voltage Power Supply for Micro-Channel Plate Photomultiplier Tubes

Design of Compact Transmission Line Transformer for High Voltage Nanosecond Pulses

500Kv Compact Repetitive Marx Generator

A pulsed power generator with a 20 stage transmission-line-transformer and 20 spark-gap switches

A High-Voltage Pulse Transformer with a Modular Ferrite Core.

A Compact High-Power Ultra-Wideband Bipolar Pulse Generator

High voltage charging system for pulsed power generators

Analysis and design of voltage doubling rectifier circuit for power supply of neutron source device towards BNCT

Design and Experiment with Miniaturized High-voltage Power Supply

A Compact Mesoband Microwave Radiation System.

High-voltage power supply for ECRH system on J-TEXT Tokamak

MHz Level Two-Stage ZVS DC-DC Converter with Wide Input and Output Voltage Ranges

Design, Simulation and Implementation of Generation of High Dc Voltage by using Cockcroft-Walton Voltage Multiplier

Design, manufacturing, and testing of 0.35/25 kV, 20 kHz transformers for particle accelerators

Optimal design of high-voltage DC power supply of 1.2 MV/45 mA applied to boron neutron capture therapy system

10 Kv Square Wave Generator

High Voltage Square Wave Generator

Compact monochromatic flash x-ray generator utilizing a disk-cathode molybdenum tube

An Ultra-High Voltage (>10 Kv) Direct-Current Triboelectric Nanogenerator Realized by Structural and Material Optimizations

Progress on the 140 KV, 10 Megawatt Peak, 1 Megawatt Average Polyphase Quasi-Resonant Bridge, Boost Converter/Modulator for the Spallation Neutron Source (SNS) Klystron Power System