Abstract:Setting blocking on the electricity transmission network distance protection is an important control measure to prevent it from malfunctioning in the out-of-step oscillation (OOSO) process. However, this operation makes it lose the ability to cut off faults. Once fault occurs, the consequences are serious, which might bring huge energy loss. How to effectively identify faults and quickly restore its protection capability is an important engineering task, but it's also filled with challenges. For the symmetrical faults occurring at δ ≈ 180 ∘ , the traditional technologies are susceptible to failure because the system seems to be oscillating continuously. For asymmetric faults, the sequence component method can be adopted, but limited by the sequence component extraction speed. Aiming at the above existing problems, this paper launches the targeted study and gives the corresponding solutions. To the former, it innovatively analyzes the variation law about the frequency difference of bus voltage (BV) and system current (SC) before and after fault occurs in the OOSO process, and gives its change range through strict mathematical derivation. Based on this, it proposes a novel one terminal setting-free distance protection unlocking scheme for symmetrical fault. Experiments show that the new variables defined in the criterion change abruptly and last for 3 sampling points after a fault. The new method can effectively identify faults occurring at δ ≈ 180 ∘ . This is an important advantage over the traditional methods. To the latter, it constructs a phasor imaginary part estimator, and proposes a sequence component transient calculation method. It greatly improves the asymmetric fault identification speed of the related method.

Adapative relaying to system oscillation

Detecting Oscillations Via Adaptive Chirp Mode Decomposition.

Adaptive Distance Relay for Preventing Error Action of Reactive Fault

SOME RESEARCH FOR DISCRIMINATING POWER SYSTEM OSCILLATION

REAL-TIME ESTIMATION OF POWER SYSTEM OSCILLATION PERIOD

A Stability Quantitative Analysis Method of Three-Phase Four-Wire Grid-Connected Systems Considering Frequency Coupling and Sequence Components Coupling

New Type Adaptive Distance Relay with Improved Performance

APPLICATION OF THE SELF-ADAPTIVE TRANSIENT CALCULATION IN ANALYSIS OF RELAYING PROTECTION

An Adaptive Compensated Virtual Impedance Method for Oscillation Suppression in DC Distribution Power Systems

Fault detection during power system out-of-step oscillation using frequency difference sudden-change of voltage and current at a single terminal bus and a novel setting-free distance protection unlocking scheme

Study on Free-oscillation Components Characteristics and Single-phase Adaptive Reclosure in Reactored Transmission Lines

SWITCH-ON FAULT DETECTION IN RELAY BASED ON TRAVELLING WAVES

Rapid Detection of Oscillation Faults Via Deterministic Learning.

Faulty phase selector based on inter-phase resistance change

Optimal autoreclosure and its application technique

Research on Oscillation Center Identification and Its Application in Distance Relay Protection

STUDY ON FAULT LOCATION OF TRANSMISSION LINES BASED UPON FAULT SWITCHING-OFF INDUCED TRANSIENT TRAVELLING WAVES

Design and application of optimal reclosure device

Observer-based Fault Reconstruction for Linear Systems Using Adaptive Sliding Mode Method.

Extended Critical Damping Adjustment Method for Electromagnetic Transients Simulation in Power Systems

Permanent Faults Identification Using Free Oscillation Frequency for Three-phase Reclosure on Transmission Lines with Shunt Reactors