Abstract:This paper proposes an all−digital calibration algorithm that utilizes a reference channel to suppress the timing mismatch in the Time−Interleaved Analog−to−Digital Converter (TIADC). The output of the reference channel is aligned with each sub−channel in turn, therefore enabling the simultaneous sampling and conversion of the same input signal. First, the statistical characteristics across the channels are employed for estimating the timing mismatch; then, by comparing the output difference between the reference channel and the sub−channels that are sampled simultaneously, the deviation of the derivator can be calibrated. Finally, combining both calibration results yields an accurate final output. This proposed algorithm provides an effective solution to improve TIADC performance in high−speed data acquisition systems. The proposed architecture is applied to a 12−bit 2.4 GS/s four−channel TIADC model, and then its effectiveness is verified. The simulation results exhibit that the Effective Number Of Bits (ENOB) at an input signal frequency of 984 MHz shows a remarkable improvement from 6.88 bits to 11.92 bits. The effectiveness of this technique is also demonstrated through the off−chip calibration of a commercial 12−bit four−channel 2 GS/s TIADC using a 680 MHz input signal that is based on the actual chip results.

A TIADC Mismatch Calibration Method for Digital Storage Oscilloscope

A Statistic-Based Calibration Method for TIADC System

A Calibration Scheme for a 800-Ms/s 14 Bit Pipelined ADC in 28-Nm CMOS

A Digital-Background TIADC Calibration Architecture and a Fast Calibration Algorithm for Timing-Error Mismatch

The fast time-interleaved ADC channel mismatch calibration method based on equivalent sampling and dynamic reference point

Timing Skew Calibration Method for TIADC-Based 20 GSPS Digital Storage Oscilloscope.

A Digital Timing Mismatch Calibration Technique in Time-Interleaved ADCs.

Calibration of Timing Mismatch in TIADC Based on Monotonicity Detecting of Sampled Data.

TIADC Digital Calibration Based on Apfft Phase Measurement

Estiamtion and Correction of Mismatch Errors in Time-Interleaved Adcs

Spectrum distribution‐based blind calibration method of mismatches for time‐interleaved ADCs

An All−Digital Timing Mismatch Calibration Algorithm Based on Reference Channel for TIADC

All-Digital Calibration of Timing Mismatch Error in Time-Interleaved Analog-to-Digital Converters.

Machine-Learning Based Mismatch Calibration for Time-Interleaved ADCs

A Wideband Timing Mismatch Calibration Design for Time-Interleaved Analog-to-Digital Converters with Fast Convergence

Calibration of Channel Mismatches in Time-interleaved ADCs Based on Multi-Frequency Reference Error Method

Calibration of Frequency Response Mismatches in Time‐interleaved Analog‐to‐digital Converter Based on Adaptive Method

An improved wide-range, low-complexity, fully-parallel digital background timing mismatch calibration method for dual-channel TIADC based on perfect reconstruction filter bank

Adaptive calibration of gain and offset errors for time-interleaved ADCs

A Bandwidth Mismatch Optimization Technique in Time-Interleaved Analog-to-Digital Converters.

A Channel Multiplexing Digital Calibration Technique for Timing Mismatch of Time-Interleaved ADCs