Abstract:This article proposes a digital control structure for a doubly decoupled gyroscope working in the Lissajous frequency-modulated (LFM) mode based on digital phase-locked loops (PLLs), which demodulates the angular rate signal directly from the readable digital gyroscope resonance frequency, eliminating the need for specific frequency readout circuits. The resonance frequencies of the LFM gyroscope working modes contain a mode mismatch frequency modulated by input angular rate, respectively, which are tracked by two digital PLLs followed by subsequent digital demodulation and filtering. A linearized model of the digital PLL is built to analyze noise and control characteristics for different PI parameters. The impact of different amplitude–phase extraction architectures on the extracted phase signal is also addressed in this article. Contrast experiments are carried out using the same gyroscope with large internal thermal stress due to the silicon-glass bonding process and no stress relief structure around the sensing element, working in the traditional amplitude-modulated (AM) mode and the LFM mode. Overall, the LFM working mode maintains its low-temperature sensitivity and high stability in spite of the large internal thermal stress in the gyroscope compared to AM working modes. The maximum scale factor variation over the temperature range from 10 °C to 50 °C is 1000 ppm for the LFM mode compared to 51 900 ppm for the AM closed mode. The maximum zero rate output drift over the same temperature range is 0.1248 °/s for the LFM mode and 10.7139 °/s for the AM closed mode. The scale factor nonlinearity is 329 ppm with an angular rate input range of ±50 °/s for the LFM mode compared to 1902 ppm for the AM closed mode. The LFM mode zero-bias fluctuation for ten days is less than 0.12 °/s. The angle random walk (ARW) and the bias instability (BI) of the LFM gyroscope are 0.316 °/ $\surd \text{h}$ and 2 °/h, respectively.

A Sub-0.1°/h Bias-Instability Split-Mode MEMS Gyroscope With CMOS Readout Circuit.

A Sub-0.1°/H Bias-Instability MEMS Gyroscope Using Resonant Constant-Frequency Driving Technique

A 0.09°/h Bias-Instability MEMS Gyroscope Working with a Fixed Resonance Frequency

A 0.57°/h Bias Instability 0.067°/√h Angle Random Walk MEMS Gyroscope with CMOS Readout Circuit

A 0.5 Degrees/H Bias Instability 0.067 Degrees/Root H Angle Random Walk Mems Gyroscope With Cmos Readout Circuit

A Digital Control Structure for Lissajous Frequency-Modulated Mode MEMS Gyroscope

Design and Test of MEMS Gyroscope Control System Based on LMSD

A Sub-µg Bias-Instability MEMS Oscillating Accelerometer with an Ultra-Low-Noise Read-Out Circuit in CMOS

Noise Analysis and Modeling for a Digital Control Architecture for Lissajous Frequency-Modulated MEMS Gyroscope with Amplitude-Modulated Readout

A MICROMECHANICAL MODE-MATCHED GYROSCOPE USING STIFFNESS NONLINEARITY AND ELECTROSTATIC TUNING

High Performance Interface Circuit for MEMS Gyroscope

Identification and Suppression of Driving Force Misalignment Angle for a MEMS Gyroscope Using Parametric Excitation

A Wafer-Level Vacuum Packaged MEMS Disk Resonator Gyroscope With 0.42°/h Bias Instability Within ±300°/s Full Scale

A sub 0.8 degree per hour mode-matching MEMS vibratory gyroscope with closed loop control for the sense mode

A Digital Mems Gyroscope With 40 Degrees/H Instability Variation In-40 Degrees C To 85 Degrees C

A Tactical-Grade Monolithic Horizontal Dual-Axis Mems Gyroscope Based on off-Plane Quadrature Coupling Suppression Silicon Gratings

A digital MEMS gyroscope with 40∘/h instability variation in −40∘C to 85∘C

Bias Thermal Stability Improvement of MEMS Gyroscope with Quadrature Motion Correction and Temperature Self‐sensing Compensation

Mems Gyroscope Bias Drift Self-Calibration Based On Noise-Suppressed Mode Reversal

4.11-Million Q-factor Whole-Angle MEMS Hemispherical Resonator Gyroscope with 0.013°/h Bias Instability

Design of an interface circuit system for mode-separation MEMS digital gyroscope