Abstract:By employing carefully controlled processing methods, a large amount of porosity (>70vol%) was introduced in ceramic materials derived from preceramic polymers (silicone resins) after pyrolysis at 1000–1200°C in inert atmosphere. The resulting components have a bulk density ranging from ∼250 to 950kg/m3. Three main fabrication methods have here been employed: (1) direct foaming of a solution of a thermosetting silicone resin in a suitable solvent (with or without the addition of polyurethane precursors), acting also as a blowing agent; (2) the use of sacrificial fillers that decompose during pyrolysis, consisting in polymeric microbeads; (3) the mixing of preceramic polymers possessing different characteristics, in particular ceramic yield, depending on their molecular structure. In addition to that, several methods for developing micro- or meso-pores within the resulting SiOC macro-porous ceramics were explored, with the aim of fabricating components with hierarchical porosity. These include a controlled thermal treatment, the addition of fillers with a high specific surface area (SSA), the deposition of zeolites or meso-porous silica coatings, the infiltration with aerogels, selective etching of the SiOC material and the in situ formation of C-based nanostructures. Depending on the fabrication procedure adopted, cells with an average size ranging from the micrometer to the millimeter were obtained. All these processes are simple, economical and versatile, and large bodies with various shapes (tubes, plates, blocks) can be produced, possessing a wide range of morphologies and properties. Compression strength, flexural strength and Young's modulus vary with the morphology and density of the porous components. It is also possible to add to the preceramic polymers some filler powders, for instance possessing electrical conductivity or magnetic properties, leading to the production of functional cellular ceramics.

3D printing of open-porous cellular ceramics with high specific strength

Bioinspired Large-Scale Aligned Porous Materials Assembled with Dual Temperature Gradients

3D Printing of Hollow Microspheres into Strong Hierarchical Porous Ceramics

Ultrahigh Strength of Three-Dimensional Printed Diluted Magnesium Doping Wollastonite Porous Scaffolds

3D printing boehmite gel foams into lightweight porous ceramics with hierarchical pore structure

Structure design influencing the mechanical performance of 3D printing porous ceramics

Design and Manufacturing of Si-Based Non-Oxide Cellular Ceramic Structures through Indirect 3D Printing

Sophisticated Structural Ceramics Shaped from 3D Printed Hydrogel Preceramic Skeleton

Ultrahigh-Strength Porous Ceramic Composites via a Simple Directional Solidification Process

Additive manufacturing of interconnected hierarchically porous zirconia: Utilizing both microspherical and filamentary pore-forming agents via direct ink printing

Hierarchical cellular scaffolds fabricated via direct foam writing using gelled colloidal particle‐stabilized foams as the ink

Highly Porous ZrO2 Cellular Ceramics with 3D Network Architecture

3D Printing Bioinspired Ceramic Composites

3D printing of hollow lattice structures of ZrO2(3Y)/Al2O3 ceramics by vat photopolymerization: Process optimization, microstructure evolution and mechanical properties

Three-Dimensional Printing of Cuttlebone-Inspired Porous Ceramic Materials

Preparation and stereolithography 3D printing of ultralight and ultrastrong ZrOC porous ceramics

Robocasting of highly porous ceramics scaffolds with hierarchized porosity

Employing a combination of direct ink writing and near-infrared-induced photopolymerization facilitates 3D printing of unsupported multi-scale ceramics: The bone tissue engineering approach

A bioinspired surface tension-driven route toward programmed cellular ceramics

Direct 4D printing of gradient structure of ceramics

Engineering porosity in polymer-derived ceramics