Effect of extra added Mg2+ and Si4+ on the microstructure and luminescence properties of Ce:YAG ceramic phosphors for high power LED/LD lighting
Qian Zhang,Yun Shi,Denis Kosyanov,Yifei Xiong,Tong Wu,ZhenZhen Zhou,Qian Liu,Jinghong Fang,Jinqi Ni,Huan He,Jianding Yu,Mingjun Niu,Wentao Liu
DOI: https://doi.org/10.1016/j.ceramint.2022.11.331
IF: 5.532
2023-04-01
Ceramics International
Abstract:The study deals with the use of different amounts of MgO or tetraethyl orthosilicate (C8H20O4Si, TEOS), from 0.04 wt %, 0.06 wt %, 0.08 wt %, 0.4 wt %, 0.6 wt % to 0.8 wt %, respectively, as additional sintering aids during the vacuum sintering of transparent Ce3+ doped Y3Al5O12 (Ce:YAG) ceramics to investigate their effect on microstructure and luminescence properties. A comparative study was carried out by using X - ray diffraction, scanning electron microscopy/energy dispersive X - ray spectroscopy, optical and photo-luminesce spectra, as well as electroluminescent spectra. The dominant garnet phase was obtained even when adding 0.8 wt % of MgO or TEOS, while adding MgO led to finer average grain size (∼ 5 - 10 μm) and more homogenous distribution compared to TEOS (∼ 20 - 25 μm) in Ce:YAG ceramics. Adding a large amount of MgO was found to result in the segregation of MgO in Ce:YAG ceramics, while an excess of TEOS led to the segregation of Al2O3. A strong absorption peak at 308 nm was observed in Ce:YAG ceramics with MgO sintering aids, which was ascribed to the existence of Ce4+ induced by a charge compensation effect of Mg2+. The optimum transmittance reached 80% @ 800 nm in Ce:YAG ceramics when adding 0.6 wt % TEOS, which also exhibited a maximum luminous efficacy of 106 lm/W. Si4+ was experimentally proved to have a better optimization effect on luminous efficacy compared to Mg2+.
materials science, ceramics