Abstract:As one of the important parameters characterizing the cable's operation status, an accurate measurement of the current is particularly important for the cable's reliable operation and status monitoring. Aiming at the problem that the sum of the current phasors of multiphase cables is 0 when running in a steady state, and that the traditional mutual inductance current measurement method cannot be used for the phase current measurement of such cables, or that the insulation layer needs to be damaged, this paper proposes a non-contact measurement method of three-phase cable current, based on the magnetic field decoupling calculation. When combined with the actual parameters of the three-phase cable, the analytical calculation model of the magnetic field distribution of the three-phase cable is established. The relationship between the output ratio of the sensor and the deflection angle is obtained through theoretical derivation, the magnetic field coupling coefficient matrix is determined, and the transfer relationship between the output of the magnetic sensor and the current of each phase is clarified; an array magnetic field sensor is designed, which can sense the information of the adjacent magnetic field independently and is used for the reconstruction of three-phase currents. The effectiveness of the proposed method was tested on the built three-phase four-core cable current measurement test platform. The experimental results show that under the three-phase current balance, the measurement error of phase A, phase B and phase C is less than 2.8%, and the waveform and phase angle of the three-phase current can be well restored, which verifies the three-phase current measurement method proposed in this paper.

Online Measurement Method Of Phase Difference Of Current Sensor Based On Cca

A Differential Compensated Air Coil Current Sensor for Switching Current Measurement of Power Devices.

Harmonic and Reactive Current Synchronous Detecting Method Based on DSP

A NEW METHOD FOR REAL-TIME DETECTING HARMONICS AND REACTIVE CURRENTS IN SINGLE-PHASE CIRCUIT

A New Accurate Measuring Method of Phase Difference Suitable for Asynchronous Sampling

A Single-phase Harmonic Current Detecting Method Based on Phase-shifted Cancellation

The Application of Non-Invasive Sensor in Unbalanced Three-Phase Current Detecting

Self-Calibration of Phase Current Sensors with Sampling Errors by Multipoint Sampling of Current Values in a Single PWM Cycle.

An Algorithm of Phase Difference Measurement Based on Fourier Series with Application in Detection of MOA

An Amplitude-Phase Measurement Method for Cross-Eye Jammers

A New Current Measurement Method Based on Circular Tunneling Magnetoresistive Sensor Array

A Novel Single-Phase Reactive Current Detection Algorithm Based on Fast Orthogonal Signal Generator and Enhanced Moving Average Filter

Measuring method for phase current of symmetrical three-core power cable based on magnetic sensors

New Phase Difference Measurement Based on Digital Synchronous Demodulation

Non-Contact Measurement Method of Phase Current Based on Magnetic Field Decoupling Calculation for Three-Phase Four-Core Cable

Study on two methods for harmonic detection of single-phase circuit

A Phase Difference Measurement Method for Integrated Optical Interferometric Imagers

A Method to Detect Three-Phase Fundamental Positive-Sequence Active Current Based on Single-Phase Cascaded Delayed Signal Cancellation

A Novel Low-Cost Multicoil-Based Smart Current Sensor for Three-Phase Currents Sensing of Overhead Conductors

A High-Performance Current Sensing Circuit with Full-Phase Sampling Capability

Harmonic and interharmonic measurement methods based on IEC standard and all-phase spectrum analysis