Abstract:In response to the demand for short-range detection of anti-smoke environment interference by laser fuzes,this study proposes a smoke environment simulation of non-uniform continuous point source diffusion and investigates an experimental laboratory smoke environment using an ammonium chloride smoke agent.The particle size distribution,composition,and mass flow distribution of the smoke were studied.Based on a discrete phase model and a k-ε turbulence model,a numerical simulation was developed to model the smoke generation and diffusion processes of the smoke agent in a confined space.The temporal and spatial distribution characteristics of the smoke mass concentration,velocity,and temperature in the space after smoke generation were analyzed,and the motion law governing the smoke diffusion throughout the entire space was summarized.Combined with the experimental veri-fication of the smoke environment laboratory,the results showed that the smoke plume changed from fan-shaped to umbrella-shaped during smoke generation,and then continued to spread around.Meanwhile,the mass concentration of smoke in the space decreased from the middle outward;the changes in temperature and velocity were small and stable.In the diffusion stage(after 900 s),the mass concentration of smoke above 0.8 m was relatively uniform across an area of smoke that was 12 m thick.The concentration decreased over time,following a consistent decreasing trend,and the attenuation was negligible in a very short time.Therefore,this system was suitable for conducting experimental research on laser fuzes in a smoke environment.Owing to the stability of the equipment and facilities,the setup could reproduce the same experimental smoke environment by artificially controlling the smoke emission of the smoke agent.Overall,this work provides a theoretical reference for subsequent research efforts regarding the construction of uniform smoke environments and evaluating laser transmission characteristics in smoky environments.

Test Method of Propellant Smoke Density Based on Image Sensor

Analysis of Temporal and Spatial Distribution Characteristics of Ammonium Chloride Smoke Particles in Confined Spaces

A New Fluorescent Probe Based on BODIPY for Testing NO2 Released from Propellants

Light transmittance measurement method of solid rocket motor plume based on laser modulation spectrum analysis

Measurement of Charge Density in Methane Fired Diffusion and Premixed Flames Using Electrostatic Probes

Diagnostics of Flame Temperature Distribution of Solid Propellants by Spectrographic Analysis

3D Trajectory, Morphology and Phase Discrimination of Burning Al/AP Propellant Particles with Time-Resolved Astigmatic Dual-Beam Interferometric Particle Imaging

Dynamic Smoke Particle Size Distribution in Test Fire

Study On Fire Detection Method Based On Particle Image Analysis

GFC Photoacoustic Measurement Method for Fire Products

An experimental study on the particle concentration and size distribution of smoke generated by flaming N-heptane

Development of a Solid, Low-Smoke Rocket Propellant – Smoke Generation Intensity Tests Using a Laser and Photodiode Setup

Remote Passive Detection of Flame Temperature of Solid Propellant Adulterating Nanoparticles

A New Method of Laser Sheet Imaging-Based Fire Smoke Detection

A Novel Protocol to Measure the Attenuation of Electromagnetic Waves Through Smoke

A Novel Smoke Concentration Detection Model Derived by Combining HSL Space and Improved Dark Channel

Photoacoustic Combined Sensing for CO and Smoke in Fire Products

Research on a capacitive particle analysis smoke detector

PRELIMINARY COMPARISON ON THE MORPHOLOGIES OF SMOKE PARTICLES AND DUSTS THROUGH SEM IMAGING

Synchronized measurement method of burning rate and combustion temperature of a solid propellant specimen

INFLUENCE ON PERFORMANCE OF SMOKE FIRE DETECTORS BY VELOCITY