Abstract:Wide-bandgap all-inorganic CsPbIBr 2 solar cells with MoO x /Ag/TeO 2 composite transparent electrode have been firstly used to construct a 4T perovskite/Si-heterojunction tandem cells. The calculation results showed that the long wavelength transmission (600 to 1100 nm) of MoO x /Ag film can be enhanced remarkably by adding a TeO 2 optical capping layer. This resulted in an obviously increase of the PCE (J SC ) from 10.70% (17.56 mA/cm 2 ) to 14.76% (24.67 mA/cm 2 ) for corresponding bottom Si cell in CsPbIBr 2 /Si devices, although the PCE of top CsPbIBr 2 cell decreased from 17.52% to 16.58%, the overall PCE of tandem device has increased from 28.22% to 31.34%. This J SC -dependent PCE improvement mainly came from the more balanced light absorption, which can be understood by the optical interference induced light field redistributions in CsPbIBr 2 /Si devices. Specially, comparing with the original Si cell, the J SC and PCE losses in bottom Si cell have been suppressed to about 33% and 32%, which are superior to most the reported pervoskite/Si tandem cells. Therefore, the tandem of Si cell and CsPbIBr 2 cell with optimized MoO x (20 nm)/Ag(8 nm)/TeO 2 (50 nm) transparent electrode could be the promising cost-effective photovoltaic in the future. This work is instructive to the fabrication of pervoskite/Si tandem solar cells.

Transparent Electrode for Monolithic Perovskite/silicon-Heterojunction Two-Terminal Tandem Solar Cells

Efficient Semitransparent Perovskite Solar Cells Using a Transparent Silver Electrode and Four-Terminal Perovskite/Silicon Tandem Device Exploration

Cerium-doped Indium Oxide Transparent Electrode for Semi-Transparent Perovskite and Perovskite/silicon Tandem Solar Cells

Enhanced optoelectronic coupling for perovskite-silicon tandem solar cells

Highly conductive and broadband transparent Zr-doped In<sub>2</sub>O<sub>3</sub> as the front electrode for monolithic perovskite/silicon tandem solar cells

Interface Reactive Sputtering of Transparent Electrode for High‐Performance Monolithic and Stacked Perovskite Tandem Solar Cells

Efficient Monolithic Perovskite-Si Tandem Solar Cell Enabled by an Ultra-Thin Indium Tin Oxide Interlayer

Semitransparent perovskite solar cells with ultrathin silver electrodes for tandem solar cells

Perovskite-silicon tandem solar cells with bilayer interface passivation

Optical Design of Monolithic Two-Terminal Perovskite/Si Tandem Solar Cells for Efficient Photon Management

Transparent Recombination Electrode with Dual‐Functional Transport and Protective Layer for Efficient and Stable Monolithic Perovskite/Organic Tandem Solar Cells

Perovskite/silicon-based Heterojunction Tandem Solar Cells with 14.8% Conversion Efficiency Via Adopting Ultrathin Au Contact

High-Performance Perovskite/Cu(In,Ga)Se-2 Monolithic Tandem Solar Cells

Efficient Perovskite/Silicon Tandem Solar Cells on Industrially Compatible Textured Silicon

Multilayer Transparent Top Electrode for Solution Processed Perovskite/Cu(In,Ga)(Se,S)2 Four Terminal Tandem Solar Cells.

Wide-Bandgap All-Inorganic CsPbIBr<sub>2</sub> Top Cells With MoO<sub>x</sub>/Ag/TeO<sub>2</sub> Composite Transparent Anode Towards Efficient Four-Terminal Perovskite/Si Tandem Solar Cells

Monolithic perovskite/organic tandem solar cells with 23.6% efficiency enabled by reduced voltage losses and optimized interconnecting layer

Efficient and stable perovskite-silicon tandem solar cells with copper thiocyanate-embedded perovskite on textured silicon

Highly conductive and broadband transparent Zr‐doped In2O3 as the front electrode for monolithic perovskite/silicon tandem solar cells

Efficient and Reproducible Monolithic Perovskite/Organic Tandem Solar Cells with Low-Loss Interconnecting Layers

Large Area 23%-Efficient Monolithic Perovskite/Homo-Junction-Silicon Tandem Solar Cell with Enhanced UV Stability Using Down-Shifting Material