Oleic Acid Surface Modification in the Preparation of Magnetic Nanoparticles by a Chemically Induced Transition

Xiangshen Meng,Zhenghong He,Jianwei Zhao,Yueqiang Lin,Xiaodong Liu,Decai Li,Jian Li,Xiaoyan Qiu
DOI: https://doi.org/10.1109/tmag.2017.2755600
IF: 1.848
2017-01-01
IEEE Transactions on Magnetics
Abstract:Using a chemically induced transition method, magnetic nanoparticles of gamma-Fe2O3 coated by FeCl3 center dot 6H(2)O (gamma-Fe2O3/FeCl3 center dot 6H(2)O nanoparticles) can be prepared. Surface modification is performed using oleic acid. By adding oleic acid during the synthesis, FeCl3 center dot 6H(2)O can be replaced to produce nanoparticles of gamma-Fe2O3 coated by a monolayer of oleic acid (gamma-Fe2O3/oleic acid nanoparticles). The amount of oleic acid added is sufficient, with the as-prepared sample single gamma-Fe2O3/oleic acid nanoparticles, whereas the as-prepared sample is a mixture of both gamma-Fe2O3/FeCl3 center dot 6H(2)O and gamma-Fe2O3/oleic acid nanoparticles. By chemical species analysis, the mass fraction of both the gamma-Fe2O3 phase and oleic acid adsorbed can be estimated. These magnetic nanoparticles coated by oleic acid can be considered as effective nanoparticles with an effective density rho(p.e). The rho(p.e) reflects the amount of oleic acid chemisorbed on the nanoparticles. A kerosene-based suspension comprising the effective nanoparticles was synthesized. Results for the specific saturation magnetization sigma(f.s) and density rho(f) of the suspension confirm the effective particle structure, involving the mass fraction of oleic acid adsorbed and the effective density of the effective particles.
What problem does this paper attempt to address?