Abstract:Flux-switching permanent magnet (FSPM) machines are gaining in popularity due to their robustness, wide speed range, high torque, and high power density. However, their cogging torque leads to vibration and noise due to the double-saliency structure. This paper investigates the effects of the short permanent magnet (PM) and stator flux bridge (FB) on the cogging torque reduction of three-phase 12-/10-pole FSPM machines. Four different FSPM machines, including the inner-inner topology, inner-outer topology, outer-inner topology, and outer-outer topology, are developed and analyzed with both short PM and stator FB. The configurations are obtained by placing the FB at inner/outer stator lamination and reducing the PM toward inner/outer axial directions. The cogging torque, average output torque, and PM utilization ratio of different topologies are extensively studied and compared by the finit-eelement method. Finally, prototype machines are manufactured and tested. The experimental results have validated the numerical models and the effectiveness of the developed machine in reducing the cogging torque. The results also suggest that the outer-inner topology is more effective to reduce the cogging torque, which not only reduces the utilization of the PM materials, but also mitigates the cogging torque at only slight cost of machine performance.

FEA-Based Design and Comparative Study of Axial Flux Permanent Magnet Machines with Various Topologies

Optimization and Comparison of Dual-Armature Flux-Switching Permanent Magnet Machines with Different Stator Core Shapes

Comparative Study of Novel Doubly Fed Doubly Salient PM Machines with Different Stator/Rotor-Pole Number Combinations

Influence of Design Parameters on Output Torque of Novel Doubly-Fed Flux-Switching Permanent Magnet Machines

Comparison of Dual-Stator Permanent Magnet Machines with Different Rotor Topologies

Investigation of Short Permanent Magnet and Stator Flux Bridge Effects on Cogging Torque Mitigation in FSPM Machines

Comparative Study of Flux-Switching PM and EE Machines with Dual Armature Winding Configuration

Winding Configurations and Pole/Tooth Combinations of Doubly-Fed Flux-Switching Permanent Magnet Machines

Comparison Of Axial Flux Pm Synchronous Motor And Induction Motor By Mathematical And Finite Element Analysis

Combination of 2D and 3D Finite Element Models in the Design of Axial Flux Permanent Magnet Machines for Electric Vehicle Applications

Comparative Analysis of Doubly Fed Flux-Reversal Permanent Magnet Machines with Different PM Arrangements and Consequent-Pole Topologies

Comparative Study of Biased Flux PM Machines Having Different Stator Core Segments and Armature Winding Configurations

Optimal Design of an Axial Flux Permanent Magnet Motor

A Novel Doubly-Fed Flux-Switching Permanent Magnet Machine with Armature Windings Wound on Both Stator Poles and Rotor Teeth

Design and Optimization of Novel Doubly-Fed Consequent-Pole Flux Reversal Machine

Design and Analysis of Outer Rotor Permanent-Magnet Vernier Machines with Overhang Structure for In-Wheel Direct-Drive Application

Design and analysis of a new fractional-slot-windings axial-flux permanent-magnet machine

Design of Axial Flux Permanent Magnet Machines with Segmental 2D Finite-Element Method

Comparative Study of Air-Cored Axial-Flux Permanent-Magnet Machines with Different Stator Winding Configurations.

Comparisons of Permanent-Magnet Machines with Different Rotor Topologies for Quadruped Robot

Analysis of Dual-Armature Flux Reversal Permanent Magnet Machines with Halbach Array Magnets