Abstract:For large-scale offshore wind power integration to main grids over a long distance, the VSC–HVDC transmission is a typical way. However, the asynchronous characteristic of HVDC link leads to the frequency decouple of the offshore grid and the main grid, i.e., the offshore grid has little or no inertia support for the main grid. The high level penetration of wind energy makes the main grid an “inertia-less” system and impairs the overall stability of the system. This paper proposes a new coordinated control strategy which uses the electrical energy stored in the DC capacitors and the kinetic energy stored in wind turbine rotors to emulate the inertia of synchronous generators. By this control strategy, the DC link capacitors release or absorb energy following the droop DC voltage control of the grid side VSC (GSVSC), and the wind farm VSC (WFVSC) changes its output frequency according to the DC voltage. Thus, an artificial coupling of the frequencies of the two-side AC systems is obtained without remote communication. According to the WFVSC’s output frequency, the wind turbine power controller alters its power reference, and the wind turbine speed changes. Thus, the kinetic energy stored in wind turbine rotors is absorbed or released. As a result, the wind turbine is utilized to keep the main grid frequency stable. Based on the doubly fed induction generator (DFIG) wind turbine, this paper analyzes the influence of different additional power controllers and different control parameters of the proposed control strategy on the inertia time constant. Within the permissible range of the DC voltage variation, the proposed control strategy can provide a wide range of inertia time constant, which improves the overall stability of the main grid system. Simulation results of three operation conditions, i.e., sudden load changes, variation of the wind speed, and AC system faults, validated the effectiveness of the proposed coordinated control strategy.

Inertia Control of the Grid Connected Doubly Fed Induction Generator Based Wind Farm with Drive-Train Torsion Active Damping

Modeling and Control of Wind Turbine with Doubly Fed Induction Generator

A Virtual Inertia Coordinated Control Scheme of PMSG-based Wind Turbines in Weak Grids

Two-level Damping Control for DFIG-based Wind Farm Providing Synthetic Inertial Service.

Research on design and simulation experiment of virtual inertia controller for doubly fed induction generator

Multi-Timescale Control of Variable-Speed Wind Turbine for Inertia Provision

Influence of inertia response control of wind turbine with doubly fed induction generator on drive train torsional vibration

Analysis of Inertia Mechanism of Grid-tied Photovoltaic Power Generation System with Virtual Inertia Control

Torsional Oscillation Damping Control for Dfig-Based Wind Farm Participating in Power System Frequency Regulation

Inertia Optimization Control and Transient Stability Analysis of Wind Power Grid-Connected System

Multi-Objective Adaptive Inertia and Droop Control Method of Wind Turbine Generators

Torque Oscillation Suppression of DFIG-based Wind Turbines under Unbalanced and Distorted Grid Voltage Conditions

Data-Driven Virtual Inertia Control Method of Doubly Fed Wind Turbine

Research on multi-energy cooperative participation of grid frequency inertia response control strategy for energy storage type doubly-fed wind turbine considering wind speed disturbance

Rotor Inertia Adaptive Control and Inertia Matching Strategy Based on Parallel Virtual Synchronous Generators System

Adaptive Inertia Control of Virtual Synchronous Generator Based on Power Feedback

Grid-Forming Control for DFIG Based Wind Farms to Enhance the Stability of LCC-HVDC

Doubly Fed Induction Generator Wind Turbine Systems Subject to Recurring Symmetrical Grid Faults

Coordinated control of wind farm and VSC–HVDC system using capacitor energy and kinetic energy to improve inertia level of power systems

Inertia emulation control of PMSG-based wind turbines for enhanced grid stability in low inertia power systems

Design and Simulation of Frequency Controller for Doubly Fed Induction Generator