Abstract:This paper is to investigate the inertial dynamics of virtual-synchronous-controlled (VSynC) doubly fed induction generator (DFIG)-based wind turbines (WTs). VSynC, different from the conventional synchronization method based on phase-locked-loop (PLL) synchronizing technique, makes DFIG-based WT synchronize with power grid via the active power control (APC), and thus provide the desired inertial support to power grid. Further, an effective approach for describing the inertial dynamics of DFIG-based WT with VSynC is proposed by establishing the WT's electromechanical motion equation. The approach synthetically considers the impacts of the WT's different controller parameters, operating points, and, in particular, the variations of mechanical power caused by the rotational speed or pitch angle changes during the inertial response period. It also makes the essential of DFIG-based WT's inertia clearer, which, as a matter of fact, is controllable and manifests frequency-dependent characteristics, and noticeably differs from the fixed inertia time constant featured in synchronous generator (SG). The impacts of different controller parameters and operating points on single WT's frequency response characteristics are studied. Simulated results also validate the superiority of VSynC on inertial support capability and operation stability to the typical PLL-based vector control (VC), especially for weak grid conditions. Finally, the frequency response on wind power plant (WPP) level is initially explored and further research to improve VSynC is discussed.

Influence of inertia response control of wind turbine with doubly fed induction generator on drive train torsional vibration

Modeling and Control of Wind Turbine with Doubly Fed Induction Generator

Decentralized Nonlinear Control of Wind Turbine with Doubly Fed Induction Generator

Optimized design of resonant controller for stator current harmonic compensation in DFIG wind turbine systems

Small Signal Stability Analysis and Control of the Wind Turbine with the Direct-Drive Permanent Magnet Generator Integrated to the Grid

Inertia Control of the Grid Connected Doubly Fed Induction Generator Based Wind Farm with Drive-Train Torsion Active Damping

Research on design and simulation experiment of virtual inertia controller for doubly fed induction generator

A Virtual Inertia Coordinated Control Scheme of PMSG-based Wind Turbines in Weak Grids

Impact of Inertia Control of DFIG Wind Turbines on System Small-signal Stability

Modeling of Type 3 Wind Turbines with Df/dt Inertia Control for System Frequency Response Study

Analysis and Mitigation of Electromechanical Oscillations for DFIG Wind Turbines Involved in Fast Frequency Response

Multi-Objective Adaptive Inertia and Droop Control Method of Wind Turbine Generators

Two-level Damping Control for DFIG-based Wind Farm Providing Synthetic Inertial Service.

Torque Oscillation Suppression of DFIG-based Wind Turbines under Unbalanced and Distorted Grid Voltage Conditions

Torsional Oscillation Damping Control for Dfig-Based Wind Farm Participating in Power System Frequency Regulation

Data-Driven Virtual Inertia Control Method of Doubly Fed Wind Turbine

Analysis and mitigation of the drive train fatigue load for wind turbine with inertial control

Design and Simulation of Frequency Controller for Doubly Fed Induction Generator

Damping Control for Drivetrain Torsional Vibration Attenuation of Grid Forming Wind Turbines with DFIG

Inertia Response Control of Self-synchronous Voltage Source Doubly-fed Wind Turbines in the Whole Wind Speed Range

On Inertial Dynamics of Virtual-Synchronous-Controlled DFIG-Based Wind Turbines