Abstract:The heat transfer and flow of nanofluids in microchannel heat sink is usually numerically investigated by the single-phase model. The thermal conductivity and viscosity of nanofluids are calculated in the whole computational region because the single-phase model, assumes the nanofluids is static and nanoparticles concentration is uniform. However for the actual forced flow process, the concentration distribution of the nanofluids is not uniform. So the thermal properties of the nanofluids vary within different computational regions. With the increase of the velocity of the nanofluids, the deviation between the prediction of single-phase model and experimental results increases. In this paper, a new simulation method is proposed to consider the inhomogeneous and dynamic thermophysical properties of the nanofluids by obtaining the nonuniformly distributed nanoparticle concentration in each numerical cell. At the same time, it takes into account the following factors: the interactions between the nanoparticles, the solid wall and the base fluid, the axial conduction, the slip boundary conditions and fluid-solid coupling. The results show that the proposed numerical simulation method further improve the simulation accuracy for the forced flow and heat transfer process of nanofluids in the microchannel in a wider range. The effects of the nanoparticles concentration, Reynolds number and axial heat transfer on the thermophysical properties of the nanofluilds, the flow and heat transfer characteristics of a rectangular microchannels with hydraulic dimensions of 341μm were analyzed using the proposed simulation model. The main results are as follows: the nanoparticles are enriched at the near wall for the fully developed region; the nonuniformity of the nanofluilds thermal conductivity coefficient distribution at the channel cross section increases with the increase of the mass flow rate and the inlet centration; under the same Reynolds number, the higher the nanofluids concentration the better the heat transfer characteristics, but there is no linear relationship between the enhancement amplitude and concentration; the heat transfer coefficient of nanofluid with 1% and 2% alumina nanoparticles concentration is about 5.86% and 8.49% higher than that of deionized water, respectively; the axial conduction effect cannot be ignored for the microchannel, which significantly affects the inlet and outlet region of the microchannel especially when the Reynolds number is low. The nanofluilds temperature in the microchannel increases with the curve and does not match the conventional linear growth hypothesis.

A stochastic model for thermal transport of nanofluid in porous media: Derivation and applications

A spatial-fractional thermal transport model for nanofluid in porous media

Modeling Heat Transport in Nanofluids with Stagnation Point Flow Using Fractional Calculus

Stochastic Thermal Transport Of Nanoparticle Suspensions

Nanofluids Transport Model Based on Fokker-Planck Equation and the Convection Heat Transfer Calculation

Thermal Conductivity of Nanofluids and Size Distribution of Nanoparticles by Monte Carlo Simulations

Forced Convective Transport of Alumina–water Nanofluid in Micro-Channels Subject to Constant Heat Flux

Thermal driven flows inside a square enclosure saturated with nanofluids: Convection heat functions and transfer rate revisions from a homogenous model

A New Model for Heat Conduction of Nanofluids Based on Fractal Distributions of Nanoparticles

A Solid-Liquid Local Thermal Non-Equilibrium Lattice Boltzmann Model for Heat Transfer in Nanofluids. Part I: Model Development, Shear Flow and Heat Conduction in a Nanofluid

Mixed Convection of Fractional Nanofluids Considering Brownian Motion and Thermophoresis

Numerical Simulation for Microconvection Around Nano-Particle With Brownian Motion in Liquid

A Solid-Liquid Local Thermal Non-Equilibrium Lattice Boltzmann Model for Heat Transfer in Nanofluids. Part II: Natural Convection of Nanofluids in a Square Enclosure

Numerical modeling of mixed convective nanofluid flow with fractal stochastic heat and mass transfer using finite differences

Heat Transfer of Nanofluids Considering Nanoparticle Migration and Second-Order Slip Velocity

A New Model for Brownian Force and the Application to Simulating Nanofluid Flow

Effect of Temperature Jump on Forced Convective Transport of Nanofluids in the Continuum Flow and Slip Flow Regimes

Numerical Study of Natural Convection Characteristics of Nanofluids in an Enclosure Using Multiphase Model

Numerical Investigation of Laminar Convective Heat Transfer and Pressure Drop of Water-Based Al 2 O 3 Nanofluids in a Microchannel

A Fractal Model for Heat Transfer of Nanofluids by Convection in a Pool

Enhanced Heat and Mass Transfer in Porous Media with Oldroyd-B Complex Nano-Fluid Flow and Heat Source