Abstract:High-voltage and high-frequency stresses comprising of AC and DC components are encountered across the surge arresters at various nodes in HVDC stations. There is a need to generate these stresses to evaluate surge arresters employed at different locations in the HVDC networks. In the present work, an attempt is made to develop complex waveforms using a novel single-stage DC–AC converter. The presented switched-mode converter is based on a coupled inductor which gives an extra degree of freedom to obtain a higher gain with the modulation in the duty ratio. Fixing the turns ratio of the coupled inductor, the duty ratio is appropriately modulated to generate the complex waveform of high frequency and high amplitude. The proposed converter offers a single-stage solution for DC–AC inversion using pulse width modulation, with fewer components, higher power density, and the ability to generate a frequency of 600 Hz. The detailed converter and controller design analysis is discussed in the present investigation. The breakdown operation of the surge arrester demands a massive short-circuit current from the source side, which may be difficult to obtain if a high-gain amplifier is used without proper protection. The presented switched-mode converter-based approach rectifies the issue of the short-circuit current during the insulator breakdown. A simulation study is performed to validate the circuit for both positive and negative buck-boost regions. Further, a hardware setup is developed to verify the generation of high-frequency and high-voltage complex waveforms. The developed converter could be widely used for insulation evaluation and condition monitoring of various high-voltage equipment.

A Novel Equivalent Circuit Model Of The Surge Wave Generator

Equivalent Modeling of Direct-drive Wave Array in Frequency Domain

Characteristic of Actual Output Based Generator Modeling

Novel Simplified Model for Asynchronous Machine with Consideration of Frequency Characteristic

Equivalent Circuit Model for Modular High Voltage Power Generation Architectures

Method to Design Surge Generators

An Improved Method to Design Surge Generators

A Novel SPICE Circuit Model of Electrostatic Discharge (ESD) Generator.

A Fast EMI Model Based on Equivalent Interference Sources in Medium-Voltage Cascaded H-Bridge System

Simulation and Analysis of Electromagnetic Properties at the Secondary Port of Electronic Current Transformers Under Very Fast Transient Overvoltage

Equivalent Physical Model of Modular Multilevel Converter Considering Internal Dynamics

High-frequency Equivalent Circuit Modeling for Overvoltage Detection

Modeling of the Electrical Fast Transient/Burst Generator and the Standard Injection Clamp.

Design of Combined Wave Generator by Using Universal Variable Method

Novel complex waveform generator for evaluation of HVDC station class surge arresters

FE-based equivalent circuits for simulating transformer internal faults

A Coupled 3D FEM-Distribute Circuit Model for Numerical Analysis of Small Time Scale Transients of an IGBT based Inverter

A Novel Nonlinearly Equivalent Circuit Model for Calculating Electric Fields Along the Stator End-winding of HV Rotating Machine

A Circuit Model in a Wide Frequency Range for Power Transformer and Analysis of Its Characteristics

Modeling the Performance of Electromagnetic Pulse Generation Circuit Based on Avalanche Transistor Switches

Novel Equivalent Circuit Model Applicable to All Operation Modes for Brushless Doubly-Fed Induction Machines