Abstract:A new optical capillary cell was constructed from square cross-sectioned fused silica-capillary tubing (300 µm × 300 µm with cavities of 100 µm × 100 µm or 50 µm × 50 µm) and a high-pressure valve that allows room-temperature studies of fluids at pressures up to 100 MPa. This capillary cell has the advantage of very precise study of fluid systems under 100 MPa pressures, not easily done in diamond anvil cells. Several key features of this cell include: (1) The ability to directly load sample fluids and monitor pressure during investigation, (2) The lack of optical distortion, (3) The small cell volume suitable for samples of limited supply (e.g. commercially available gas mixtures), (4) The high pressures that can be achieved, (5) The high-magnification, high-numerical aperture objective lens (e.g. 100×) with a short working distance that can be used due to the thin wall of the capillary tube, and (6) The heating–cooling stage or a circulating fluid bath that can be added, allowing for investigations at temperatures other than room temperature, particularly suitable for studies of gas hydrates. Raman spectra have been collected from the cell at room temperature for methane, ethane, propane, n-butane, and for two gas mixtures containing up to nine components as a function of pressure up to 70 MPa. The spectra document the shift in Raman bands with pressure as well as constrain the detection limits for various gas species in the mixtures. Preliminary experiments on the diffusion of methane in water were conducted by monitoring the concentration of dissolved methane in water as a function of time and distance from the vapor–water boundary, immediately after perturbation of an equilibrium state induced by a sudden incremental change in methane pressure.

Gas encapsulation technology for large volume press

Optimizing Preloading Pressure of Pre-Charged Gas for Isobaric Gas-Tight Hydrothermal Samplers

Unveiling the Porosity Effect of Superbase Ionic Liquid-Modified Carbon Sorbents in CO 2 Capture from Air

A Hybrid Pressure Cell of Pyrophyllite and Magnesium Oxide to Extend the Pressure Range for Large Volume Cubic Presses

Note: an Anvil-Preformed Gasket System to Extend the Pressure Range for Large Volume Cubic Presses.

Preservation of high-pressure volatiles in nanostructured diamond capsules

Two stage 6-8 Type Large Cavity Static High Pressure Device Based on the Domestic Cubic Press

A new optical capillary cell for spectroscopic studies of geologic fluids at pressures up to 100 MPa

A gas chromatography system for measuring carbonaceous gases released at high-pressure and high-temperature conditions

Sample heating above 1400 K in a diamond anvil cell

Compression Rate of Dynamic Diamond Anvil Cells from Room Temperature to 10 K

Preserving a large-scale reversible high-pressure phase under ambient conditions

A Diamond Gasket for the Laser-Heated Diamond Anvil Cell

High-pressure fluorescence measurements using a diamond anvil cell (DAC)

A diamond anvil microassembly for Joule heating and electrical measurements up to 150 GPa and 4000 K

Exploring toroidal anvil profiles for larger sample volumes above 4 Mbar

High Gravity-Enhanced Direct Air Capture: A Leap Forward in CO2 Adsorption Technology

Gearbox designs for the diamond anvil cell: Applications to hard-to-reach-places

Diamond Anvil Cell Behavior Up to 4 Mbar

Operation of Large-Volume Cubic Press above 8 GPa and 2500°C with a Centimeter-Sized Cell Volume Using an Optimized Hybrid Assembly