Abstract:The stereo-vision methods have been developed and used for measuring the wing deformation while the aircraft is in flight. However, it is difficult to achieve accurate measurement in flight test since inevitable camera movements often occur due to elasticity in the camera support and the surrounding structure, especially during heavy turbulence and large maneuver flight. Any slight camera movements within a stereo-vision system can directly influence the calibrated extrinsic parameters, then decrease 3D reconstruction accuracy, and even cause the measurement to fail. This study proposes a method to correct the effect of the camera movements to enable accurate wing deformation measurement using a stereo-vision system. A reference coordinate system is established based on the control points to unify the changing camera coordinate system. A dynamic extrinsic parameters calibration algorithm is developed to estimate the instantaneous position and orientation of the stereo cameras. To verify the presented method, an experiment in which the stereo cameras occurring relative movement was performed. The results show that the proposed method has effectively corrected the effects of camera movements. Furthermore, the proposed method was applied to the practical wing deformation measurement of a UAV in fieldwork. The maximum error of length and displacement is less than 0.8 mm when the stereo cameras remained unchanged. The actual accuracy of the overall measurement system is about 0.01% of the observed area (e.g. 0.8 mm in 6 m scale) under the conditions of flat viewing angle and outdoor scenes. While camera movements occur during the test, the corrected RMS error of displacement is reduced to about 1.5 mm and has decreased by 50% compared with that before correction. The enhanced precision and robustness of wing deformation measurement are well realized by the proposed method of correcting camera movements.

Airplane Wing Deformation and Flight Flutter Detection Method by Using Three-Dimensional Speckle Image Correlation Technology.

Full-field Wing Deformation Measurement Scheme for In-Flight Cantilever Monoplane Based on 3D Digital Image Correlation

3D full-field wing deformation measurement method for large high-wing airplanes

Interference detection method of wing-fuselage joints based on measured data

Motion data integration and monitoring of digital assembly system of aircraft

A novel videogrammetry-based full-field dynamic deformation monitoring method for variable-sweep wings

Application of the Speckle Technique for Three-Dimensional Deformation Measurement

Wing deformation measurement using the stereo-vision methods in the presence of camera movements

Research on Measurement and Deformation of Flexible Wing Flapping Parameters

Three-Dimensional Digital Image Correlation Based on Speckle Pattern Projection for Non-Invasive Vibrational Analysis

3D Digital Speckle Analysis System for Dynamic Strain Measurement in Sheet Deformation

Method to Measure 3D Deformation Using Defocused Images of Objects with Artificial Speckle Features

Wing Deformation-Aware Vision-Based Airplane Attitude Measurement

Dynamic Deformation Measurement Of Specular Surface With Deflectometry And Speckle Digital Image Correlation

High-Accuracy Three-Dimensional Deformation Measurement System Based on Fringe Projection and Speckle Correlation

Dynamic Deformation Measurement of Bionic Flapping-Wing Robot Based on Fiber Bragg Grating Array

3D Deformation Measurement by Digital Speckle Correlation Method and Stereo Vision

High Speed Deformation Measurement Using Digital Speckle Correlation Method

A new deformation monitoring method for a flexible variable camber wing based on fiber Bragg grating sensors

Measurement of deformations for copper/aluminum clad under tension with digital speckle correlation

Robust Vision-Based Method for Wing Deflection Angle Measurement with Defocus Images