Abstract:Continuous exploitation in mining areas damages the surrounding environment and has various severe geological impacts. Hence, long-term monitoring of mining areas is crucial to reducing these impacts. Differential interferometric synthetic aperture radar (D-InSAR) is widely applied to monitor the subsidence in mining areas, but it cannot obtain accurate large-gradient subsidence result in the centre of the subsidence basin in mining areas due to the de-coherence phenomenon. The probability integral method (PIM) is a prediction method that can cooperate with D-InSAR (D-InSAR PIM, DPIM) to solve the problem. However, with this method, there is early convergence of the edge subsidence in narrow and long mining areas. Moreover, the PIM can only predict the spatial domain; it cannot achieve dynamic prediction. To address the above problems in the traditional DPIM data processing process, in this study, firstly, the traditional PIM was improved by adjusting the radius of the parameter and constructed an improved DPIM (IDPIM) method. The hybrid algorithm was applied to solve the parameters of the IDPIM method and then acquire subsidence results, thus solving the early convergence of edge subsidence problem characteristic of traditional PIM prediction in mining. Additionally, an area-weighting based fusion method was proposed to integrate the IDPIM results and the D-InSAR results (Area-weighting based fusion of the IDPIM and D-InSAR results, AFID) achieving whole-basin refined subsidence in mining areas. Secondly, based on a summary of subsidence laws in mining areas, the Hossfeld model was introduced and combined with the IDPIM method (IDPIM Hossfeld, IDPIM-H) to construct a subsidence dynamic prediction method. This achieved dynamic prediction of the subsidence in mining areas. A coal mine in Ordos was used as the study area, and the feasibility of the IDPIM method, the AFID method and the DPIM-H method was verified through a comparative analysis of leveling data. The results demonstrated that: (1) The results of the IDPIM method showed 8% and 66% improvement in RMSE along the striking and dip lines, respectively, over the D-InSAR results, improving the early convergence of the DPIM along the dip direction of the mine. (2) The results of the AFID method provide a 69% improvement in whole-basin RMSE over the D-InSAR results, which improves the lack of monitoring capacity in the D-InSAR technology center. (3) The results of the DPIM-H method provide a 35% improvement in basin-wide RMSE over the D-InSAR results, solving the problem of low temporal resolution of the D-InSAR technology and realizing the dynamic prediction with high temporal resolution. These findings provide a theoretical basis for future refined exploration of dynamic subsidence in mining areas

Combining Differential SAR Interferometry and the Probability Integral Method for Three-Dimensional Deformation Monitoring of Mining Areas

Retrieving Three-Dimensional Large Surface Displacements in Coal Mining Areas by Combining SAR Pixel Offset Measurements with an Improved Mining Subsidence Model

A DPIM-InSAR method for monitoring mining subsidence based on deformation information of the working face after mining has ended

A New Method for Extracting Three-Dimensional Surface Deformation in Underground Mining Areas Based on the Differentiability of D-InSAR Line-of-Sight Displacements

A Novel Method of Monitoring Surface Subsidence Law Based on Probability Integral Model Combined with Active and Passive Remote Sensing Data

Combination of InSAR with a Depression Angle Model for 3D Deformation Monitoring in Mining Areas

Improving Boundary Constraint of Probability Integral Method in SBAS-InSAR for Deformation Monitoring in Mining Areas

Mining Subsidence Prediction Parameter Inversion by Combining GNSS and DInSAR Deformation Measurements

Refined subsidence monitoring and dynamic prediction in narrow and long mining areas based on InSAR and probabilistic integral method

A New Method of Monitoring 3D Mining-Induced Deformation in Mountainous Areas Based on Single-Track InSAR

Coal Mining Induced Land Subsidence Monitoring Using Multiband Spaceborne Differential Interferometric Synthetic Aperture Radar Data

Optimization of three-dimensional multi-level surface deformation in mining areas through integration of deformation fusion model and Lagrange multiplier method based on single high resolution OTD-InSAR pair

A New Model for three-dimensional Deformation Extraction with Single-track InSAR Based on Mining Subsidence Characteristics

Time Series InSAR Three-Dimensional Displacement Inversion Model of Coal Mining Areas Based on Symmetrical Features of Mining Subsidence

Prediction of Mining-Induced 3-D Deformation by Integrating Single-Orbit SBAS-InSAR, GNSS, and Log-Logistic Model (LL-SIG)

Research on Surface Deformation of Ordos Coal Mining Area by Integrating Multitemporal D-InSAR and Offset Tracking Technology

Deformation Monitoring and Spatiotemporal Evolution of Mining Area with Unmanned Aerial Vehicle and D-InSAR Technology

Integrated high-precision monitoring method for surface subsidence in mining areas using D-InSAR, SBAS, and UAV technologies

Research on the Applicability of DInSAR, Stacking-InSAR and SBAS-InSAR for Mining Region Subsidence Detection in the Datong Coalfield

Integration of unmanned aerial vehicle (UAV)-based photogrammetry and InSAR for mining subsidence and parameters inversion: a case study of the Wangjiata Mine, China

Deriving Mining-Induced 3-D Deformations at Any Moment and Assessing Building Damage by Integrating Single InSAR Interferogram and Gompertz Probability Integral Model (SII-GPIM)