RePWR: Wireless Power Transfer Within Reinforced Concrete

Zhihua Wang,Orfeas Kypris,Andrew Markham

DOI: https://doi.org/10.1145/2996884.2996885

2016-01-01

Abstract:Structural health monitoring of critical infrastructure is key to protect large structures from critical and potentially catastrophic failure. It is clear that for long-term and sustained operation, energy must be harvested from some source. Although a large amount of work has considered how to power sensors on the exterior of structures with solar panels or vibration harvesting, very little attention was given to the problem of how to power sensors deep within a structure e.g. within its foundations. In this paper, we investigate whether it is possible to wirelessly power sensors deep within concrete using wireless power transfer (WPT). High-frequency WPT as typically used in air experiences high losses due to the high volumetric water content of concrete and thus cannot penetrate more than a few cm. We instead exploit the fact that concrete is reinforced with thick steel rods ("rebar") to increase its tensile strength and attempt to use these rods as conduits to guide power through the structure, using low frequency magneto-induction. As an example, with a 1 W input power, 1 mW can be consistently obtained at a distance of over 300 mm, three orders of magnitude better than an air-coupled WPT for the same coil geometry. We investigate the variation in optimal operating frequency with increasing distance and show how to further increase power transfer efficiency to a distant sensor through the use of unloaded, intermediate resonators.