All-inorganic, Hole-Transporting-layer-free, Carbon-Based CsPbIBr2 Planar Perovskite Solar Cells by a Two-Step Temperature-Control Annealing Process
Cheng Wang,Junsen Zhang,Jipeng Duan,Li Gong,Jie Wu,Liangxiang Jiang,Conghua Zhou,Haipeng Xie,Yongli Gao,Haiping He,Jianguo Lu,Zhishan Fang,Bojing Lu
DOI: https://doi.org/10.1016/j.mssp.2019.104870
IF: 4.1
2019-01-01
Materials Science in Semiconductor Processing
Abstract:In this paper, all-inorganic CsPbIBr2 thin films were annealed by a two-step temperature-control process. All-inorganic, hole-transporting-layer-free, carbon-based planar perovskite solar cells (PSCs) with these CsPbIBr2 thin films (FTO/c-TiO2/CsPbIBr2/C) were fabricated. The effect of different first-step annealing temperatures during the two-step temperature-control process (50 degrees C/280 degrees C, 80 degrees C/280 degrees C, 100 degrees C/280 degrees C, 150 degrees C/280 degrees C, 180 degrees C/280 degrees C) on the photovoltaic conversion efficiency (PCE) of PSCs was investigated for the first time. When the first-step annealing temperature was 150 degrees C and the second-step annealing temperature was 280 degrees C, the highest efficiency of 8.31% was obtained. Without encapsulation, the solar cell could retain 97% of the initial PCE, when it was stored at 80 degrees C and zero humidity for 8 days. For comparison, solar cells with CsPbIBr2 films annealed by a one-step temperature-control process were fabricated. The highest PCE was 4.98%. From this, we could see that there is an increase of 66.9% in PCE, through using a two-step temperature-control annealing process. And also, in order to investigate why the PSCs by a two-step temperature-control annealing process has a higher PCE, all kinds of measurements were done for the first time. According to the results of the measurements, the perovskite film annealed by a two-step temperature-control process has a bigger crystal size, fewer grain boundaries, stronger PL and UV-vis absorption intensities, longer lifetime of minority carriers, less energy loss for hole transporting.