Abstract:Although 4Ce4YSZ has high corrosion resistance, it faces challenges concerning its sinterability and ionic conductivity. Therefore, we studied destabilization behavior caused by corrosion and oxygen vacancy ordering according to ZnO doping. Powders of (4Ce4YSZ)1−x(ZnO)x (x = 0.5, 1, 2, 4 mol%) were synthesized using the sol-gel method. With the addition of ZnO, the cubic phase increased, and secondary phases were not observed. The (111) peak showed a higher angle shift in ZnO-doped 4Ce4YSZ compared to 4Ce4YSZ, and TEM-SAED revealed a reduction in the spacing of the (011)t plane, suggesting lattice contraction due to the substitution of the smaller Zn2+ (60 Å) for Zr4+ (84 Å) in the lattice. The local atomic structure analysis was conducted using EXAFS to investigate the oxygen vacancy ordering behavior. Zr K-edge Fourier transform data revealed a decrease in the Zr-O1 peak intensity with an increasing amount of ZnO doping, indicating an increase in oxygen vacancies. The Zr-O1 peak position shifted to the right, leading to an increase in the Zr-O1 interatomic distance. In the Y K-edge Fourier transform data, the Y-O1 peak intensity did not decrease, and there was little variation in the Y-O1 interatomic distance. These results suggest that the oxygen vacancies formed due to ZnO doping are located in the neighboring oxygen shell of Zn, rather than in the neighboring oxygen shells of Y and Zr. Impedance measurements were conducted to measure the conductivity, and as the amount of ZnO doping increased, the total conductivity increased, while the activation energy decreased. The increase in oxygen vacancies by ZnO doping contributed to the enhancement of conductivity, and it is considered that these created oxygen vacancies did not interact with Zn2+ and did not form defect associations. Fluoride-based molten salts were introduced to the specimens to assess the corrosion behavior in a molten salt environment. Yttrium depletion layers (YDLs) were formed on the surfaces of all specimens due to the leaching of yttrium. However, Ce remained relatively stable at the interface according to EDS line scans, suggesting a reduction in the phase transformation (cubic, tetragonal to monoclinic) typically associated with yttrium leaching in YSZ.

Rare-earth elements improving the corrosion resistance of YSZ/CMAS heterojunction with stacking faults: First-principles calculation

Activating Continuous Dislocation Pinning Enhanced Toughness of Nanocomposite Coating Through Specially Oriented Semicoherent Heterointerface Lattice Distortion

Effect of Er dopant on the corrosion resistance of YSZ in CMAS melt: experimental and first-principles study

Doped effect of Gd and Y elements on corrosion resistance of ZrO2 in CMAS melt: First-principles and experimental study

Grain boundary corrosion mechanism of YSZ thermal barrier oxides under CMAS attack

Improvement on Corrosion Resistance of Molten Calcium-Magnesium-Alumina-Silicate (cmas) by Yb2o3-Y2o3 Co-Stabilized Zro2 Ceramic Pellets

Effect of modulating the phase structure of YSZ ceramics by TiO 2 doping on the CMAS corrosion resistance at 1250 °C

Calcium-Magnesium-Aluminum-Silicate (CMAS) Corrosion Resistance of Y-Yb-Gd-Stabilized Zirconia Thermal Barrier Coatings

Mechanical properties and calcium–magnesium–alumino–silicate corrosion behaviour of Ce/Gd co-doped SrZrO3 ceramics

Comparison of corrosion behaviors of Sc2O3-CeO2 co-stabilized ZrO2 and YSZ ceramics exposed to CMAS at 1250°C

Oxygen Vacancy Ordering and Molten Salt Corrosion Behavior of ZnO-Doped CeYSZ for Solid Oxide Membranes

The corrosion behavior of Sc2O3-Y2O3 co-doped ZrO2 influenced by Sc2O3 content in CMAS at 1300 °C

Phase Stability and Slag-Induced Destabilization in MnO2 and CeO2-Doped Calcia-Stabilized Zirconia

Phase transformation failure in YSZ TBCs induced by component-dependent CMAS corrosion

Evolution of Microstructure, Thermophysical and Mechanical Properties and Wetting Behavior of Plasma-Sprayed Yb2O3 and Y2O3 Co-Stabilized ZrO2 Coatings During High-Temperature Exposure and CMAS Corrosion

Sc3+:Ce4+:Y3+ doped zirconia nanopowders (ScCeYSZ): Synthesis, thermal phase stability and hot corrosion behavior of spark plasma sintered body

Enhancing corrosion resistance of AZ91D alloy through yttria-stabilized tetragonal zirconia (YSTZ)/MgO repaired ceramic coating with improved embrittlement cracking

CMAS corrosion resistant of La3+-Yb3+-Ce4+ co-doped ZrO2 based TBCs: Experimental and theoretical research

CMAS corrosion resistance of scandia, ceria, yttria‐stabilized zirconia ceramic

Influence of Yttria content in YSZ: An evaluation of water-based SPS coatings and spark plasma sintered pellets

Stacking fault energy and ductility in a new zirconium alloys: A combined experimental and first-principles study