Abstract:Inertial sensors are key components of gravitational wave observations and Earth geodesy missions. An inertial sensor includes an isolated free-floating test mass (TM) surrounded by capacitive electrodes and a housing frame (EH) to perform the relative-position measurement and control the TM in six degrees of freedom. Owing to galactic cosmic rays and solar energetic particles, many additional accelerations are introduced through the Coulomb interaction between charged TMs and their surrounding conducting surfaces. Thus, the TM charge control is critical in space-based missions. A contact-free and ultraviolet light-based charge management system (CMS) was developed to reduce charge-induced noises acting on the TMs and minimize force disturbances that can perturb measurements or interrupt science tasks. However, the operating environment for space charge control is full of uncertainties and disturbances. Physical parameters in the discharging process are rarely measured and will vary owing to changes in solar activity, temperature, and so on. The unpredictability and variability of these parameters affects the CMS performance in long-term space missions and must be evaluated or eliminated. This paper presents a simplified physical model for the discharge process based on electron exchange between the TM and the opposing EH. Subsequently, a model reference adaptive control (MRAC) is proposed for the CMS with parametric uncertainties to maintain the TM charge below a certain level and improve its robustness. The simulation results show that the MRAC can automatically adjust control parameters to eliminate the effect of the variability of the aforementioned physical parameters, and the control precision can reach 0.1 mV under uncertainties, which is superior to that of a classic proportional-integral-derivative controller. This study demonstrated the effects of adaptive charge control and its potential for actual applications.

Test mass charge estimation for the space inertial sensor with extended Kalman filter

Adaptive Charge Control for the Space Inertial Sensor

High-Precision Inertial Sensor Charge Ground Measurement Method Based on Phase-Sensitive Demodulation

On-orbit calibration technique for residual magnetism fluctuation of micro-satellite

Charging and Discharging Modeling of Inertial Sensors Based on Ultraviolet Charge Management

Using finite element simulation to evaluate charge measurement precision for space inertial sensors

A Dual-Linear Kalman Filter for Real-Time Orientation Determination System Using Low-Cost MEMS Sensors

Capacitive Sensing-Based Charge Measurement for Space Inertial Sensors

Modeling and Simulation of Eddy Current Dissipation Magnetic Acceleration Noise of Space Inertial Sensors

Dual-arm Coordinated Capturing of an Unknown Tumbling Target Based on Efficient Parameters Estimation

Unscented Kalman Filter For Spacecraft Attitude Estimation And Calibration Using Magnetometer Measurements

Self-Triggered Fuzzy Data-Driven Learning-Based Test Mass Suspension Control for Space Inertia Sensor

Mass Property Estimation for Mated Flight Control

Numerical modeling and experimental demonstration of pulsed charge control for the space inertial sensor used in LISA

Compounded Calibration Based on FNN and Attitude Estimation Method Using Intelligent Filtering for Low Cost MEMS Sensor Application

Multiplicative Quaternion Extended Consensus Kalman Filter for Attitude and Augmented State Estimation

LISA test-mass charging. Particle flux modeling, Monte Carlo simulations and induced effects on the sensitivity of the observatory

Low Cost IMU Attitude Estimation Algorithm Based on Measurement Adaptive Reduced DCM

Evaluation of disturbances due to test mass charging for LISA

Adaptive pose and inertial parameters estimation of free-floating tumbling space objects using dual vector quaternions

Inertia Parameter And Attitude Estimation Of Space Noncooperative Tumbling Target Based On A Two-Step Method