Abstract:Cobalt substituted magnetite, CoxFe1−xFe2O4 was synthesized via co-precipitation method for 0.0≤x≤1.0 and annealed in argon from 600 to 800°C to investigate the effect of synthesis parameters e.g. cation substitution and thermal treatment on its saturation magnetization. Particle size variation, crystallinity and cationic distribution between sublattices which resulted from the varying synthesis parameters are expected to alter the saturation magnetization of cobalt ferrite. Both thermal treatment and cation substitution are affecting the value of saturation magnetization. Correlation of microstructural properties with magnetization were analysed using TG-DTA, XRD, FTIR and VSM. Crystallinity, average crystallite size and lattice constant of the as-annealed samples is increasing with annealing temperature. The presence of maghemite and cobalt oxide as secondary phases have caused reduction in the saturation magnetization. Interestingly, increasing cobalt concentration in the samples has dramatically shifted the temperature at which magnetite transformed to maghemite. We have found that x = 0.4 is the optimum cobalt ratio at which all reactants are converted into reaction product with no incomplete reactions that contribute to the formation of impurities. Preferential occupancy of Co2+ ions on the octahedral sites is evident in the FTIR spectra with intensified octahedral band splitting in the non-stoichiometric CoxFe1−xFe2O4 (0.2≤x≤0.8), whereby the structures formed are in metastable state. It is also evident in the FTIR spectra that distinct absorption bands appeared only when the cations in both sites are well ordered. By substituting Co2+ ions, saturation magnetization keeps on increasing until x=0.4, and gradually reduced beyond that. Highest saturation magnetization (78.86 emu/g) was obtained in Co0.4Fe0.6Fe2O4 after annealing at 800°C. In conclusion, heat treatment and substitution of ferrous/ferric ions with cobalt of lower magnetic moment has amplified the super-exchange interaction between octahedral and tetrahedral sites in magnetite spinel structure for greater saturation magnetization....

Sol–gel Autocombustion Synthesis and Characterization of Fe1−xCox Alloys with Large Saturation Magnetization

Effect of Co Addition on the Phase Structure and Magnetic Properties of Fe-Si-Al Alloys

Soft Magnetism and Microwave Magnetic Properties of Fe-Co-Hf Films Deposited by Composition Gradient Sputtering

Sol–gel autocombustion synthesis of Co–Ni alloy powder

Nanocomposites of iron-cobalt alloy and magnetite: Controllable solvothermal synthesis and their magnetic properties

Facile Route to Preparation of Fe-Co Microclusters with Highly Enhanced Magnetic Performances

Large Magnetocaloric Effect and Magnetoresistance in Fe and Co Co‐Doped Ni‐Mn‐Al Heusler Alloys

Sonochemical synthesis, structural and magnetic properties of air-stable Fe/Co alloy nanoparticles

The influence of Co on the magnetic properties of Fe-Si-B-Nb-Cu system

Chemical Conversion Synthesis of Magnetic Fe1-xCox Alloy Nanosheets with Controlled Composition.

Magnetic Properties of FexCo1−x/CoyFe1−yFe2O4 Composite under Hydrothermal Condition

Soft magnetic properties of FeCoSiBC amorphous alloys with high saturation magnetization

Effect of synthesis parameters on cobalt ferrite saturation magnetization

Preparation of Cobalt- based Fine Alloy Powders and Magnetic Properties

Synthesis and Magnetic Properties of Mesostructured Γ-Fe2o3/carbon Composites by a Co-casting Method

Synthesis and Properties of Composite Magnetic Material SrCoxFe12-xO19 (x = 0–0.3)

Low Temperature Sol-gel Autocombustion Synthesis and Magnetic Properties of Magnetite

Compositional Design and Microstructural Tuning of Fe–Si–Co Soft Magnetic Alloys with Enhanced Performance

Hydrothermal Synthesis and Magnetic Properties of Co X Fe 1−x /co Y La Z Fe 3−y−z O 4 Composites

Hydrothermal-induced Oriented Growth of Fe–Co Alloy and Sm3+-substituted Magnetite Nanowire Composites

Cation Distribution and Magnetic Properties of CoAlxFe2−xO4/SiO2 Nanocomposites