Abstract:A comprehensive CFD–DEM numerical model has been developed to simulate the biomass gasification process in a fluidized bed reactor. The methodology is based on an Eulerian–Lagrangian concept, which uses an Eulerian method for gas phase and a discrete element method (DEM) for particle phase. Each particle is individually tracked and associated with multiple physical (size, density, composition, and temperature) and thermo-chemical (reactive or inert) properties. Particle collisions, hydrodynamics of dense gas-particle flow in fluidized beds, turbulence, heat and mass transfer, radiation, particle shrinkage, pyrolysis, and homogeneous and heterogeneous chemical reactions are all considered during biomass gasification with steam. A sensitivity analysis is performed to test the integrated model׳s response to variations in three different operating parameters (reactor temperature, steam/biomass mass ratio, and biomass injection position). Simulation results are analyzed both qualitatively and quantitatively in terms of particle flow pattern, particle mixing and entrainment, bed pressure drop, product gas composition, and carbon conversion. Results show that higher temperatures are favorable for the products in endothermic reactions (e.g. H2 and CO). With the increase of steam/biomass mass ratio, H2 and CO2 concentrations increase while CO concentration decreases. The carbon conversion decreases as the height of injection point increases owing to both an increase of solid entrainment and a decrease of particle residence time and particle temperature. Meanwhile, the calculated results compare well with the experimental data available in the literature. This indicates that the proposed CFD–DEM model and simulations are successful and it can play an important role in the multi-scale modeling of biomass gasification or combustion in fluidized bed reactor.

Simulation of Large Biomass Pellets in Fluidized Bed by Dem-Cfd

Development and Verification of Coarse‐grain CFD‐DEM for Nonspherical Particles in a Gas–solid Fluidized Bed

CFD-DEM Modeling of Rod-Like Particles in a Fluidized Bed with Complex Geometry

Multi-Scale Simulation of Biomass Gasification in Fluidized Beds

CFD-DEM Investigation of the Fluidization of Binary Mixtures Containing Rod-Like Particles and Spherical Particles in a Fluidized Bed

CFD-DEM Simulation of Fluidization of Polyhedral Particles in a Fluidized Bed

CFD-DEM Simulation of Fluidized Bed with an Immersed Tube Using a Coarse-Grain Model

Modeling Agglomeration Behavior in High Temperature Gas–Solid Fluidized Beds Via Monte Carlo Method

Study on a Semi-Resolved CFD-DEM Method for Rod-Like Particles in a Gas-Solid Fluidized Bed

Development and verification of coarse‐grain CFD‐DEM for non‐spherical particles in a gas‐solid fluidized bed

Simulation of the Lateral Movement on Particles Under Continuous Feeding and Discharging in a CFB Dense Zone

Numerical Simulation of Two-Dimensional Spouted Bed with Draft Plates by Discrete Element Method

CFD–DEM–VDGM Method for Simulation of Particle Fluidization Behavior in Multi-Ring Inclined-Hole Spouted Fluidized Bed

CFD–DEM simulation of biomass gasification with steam in a fluidized bed reactor

An augmented coarse-grained CFD-DEM approach for simulation of fluidized beds

Numerical investigation of the particle flow behaviors in a fluidized-bed drum by CFD-DEM

Fluidisation of spherocylindrical particles: computational fluid dynamics–Discrete element method simulation and experimental investigation

Investigating the fluidization of disk-like particles in a fluidized bed using CFD-DEM simulation

Particle-scale Simulation of Fluidized Bed with Immersed Tubes

Study of air-steam gasification of spherocylindrical biomass particles in a fluidized bed by using CFD-DEM coupling with the multi-sphere model

Numerical Simulation of Gas-particle Hydrodynamics in CFB