Abstract:Ultrasound (US) image guidance is widely used for minimally invasive procedures, but the invasive medical devices (such as metallic needles), especially their tips, can be poorly visualised in US images, leading to significant complications. Photoacoustic (PA) imaging is promising for visualising invasive devices and peripheral tissue targets. Light-emitting diodes (LEDs) acting as PA excitation sources facilitate the clinical translation of PA imaging, but the image quality is degraded due to the low pulse energy leading to insufficient contrast with needles at deep locations. In this paper, photoacoustic visualisation of clinical needles was enhanced by elastomeric nanocomposite coatings with superficial and interstitial illumination. Candle soot nanoparticle-polydimethylsiloxane (CSNP-PDMS) composites with high optical absorption and large thermal expansion coefficients were applied onto the needle exterior and the end-face of an optical fibre placed in the needle lumen. The excitation light was delivered at the surface by LED arrays and through the embedded optical fibre by a pulsed diode laser to improve the visibility of the needle tip. The performance was validated using an ex-vivo tissue model. An LED-based PA/US imaging system was used for imaging the needle out-of-plane and in-plane insertions over approach angles of 20 deg to 55 deg. The CSNP-PDMS composite conferred substantial visual enhancements on both the needle shaft and the tip, with an average of 1.7- and 1.6-fold improvements in signal-to-noise ratios (SNRs), respectively. With the extended light field involving extracorporeal and interstitial illumination and the highly absorbing coatings, enhanced visualisation of the needle shaft and needle tip was achieved with PA imaging, which could be helpful in current US-guided minimally invasive surgeries.

Surface-blended Texturing of Medical Needles for Friction Reduction Using a Picosecond Laser

Effect of Overlap and Overscan Number in Laser Surface Texturing of Medical Needles

Surface Finishing of Needles for High-performance Biopsy

Advanced Five-Plane Lancet Needle Design, Grinding, and Tissue Insertion

Effects of Needle Inner Surface Topography on Friction and Biopsy Length

Five-plane Lancet Needle Design for Soft PVC Phantom Tissue Cutting

Contributions in Medical Needle Technologies—geometry, Mechanics, Design, and Manufacturing

Tissue Cutting Mechanics and Applications for Needle Core Biopsy and Guidance

The Needle With Lancet Point: Geometry for Needle Tip Grinding and Tissue Insertion Force

Investigations into insertion force of electrochemically micro-textured hypodermic needles

Fabrication and tribological behaviors of corner-cube-like dimple arrays produced by laser surface texturing on medical needles

Enhanced Photoacoustic Visualisation of Clinical Needles by Combining Interstitial and Extracorporeal Illumination of Elastomeric Nanocomposite Coatings

Cutting Force Of Hollow Needle Insertion In Soft Tissue

Optimal Needle Design for Minimal Insertion Force and Bevel Length.

Design, Development, and Testing of Polymeric Microblades: A Novel Design of Microneedles for Biomedical Applications

Influence of a Biocompatible Hydrophilic Needle Surface Coating on a Puncture Biopsy Process for Biomedical Applications

Research on Mechanical Properties of Bevel-Tip Needle Based on Image Guidance.

Design and evaluation of a novel biopsy needle with hemostatic function

Computational and Experimental Study of Vibrational Motions on Tissue Cutting for Solid Biopsy Needles

Influence of Blended Textures Generated by Laser Surface Texturing on Friction Behavior in Soft Tissue Cutting

Modeling of geometry and insertion force of a new lancet medical needle