Abstract:The present paper is dedicated to the development of a numerical model for the water impact of two-dimensional (2D) and axisymmetric bodies with imposed motion. The work is a first step towards the implementation of a 2D+t procedure to be used for the analysis of aircraft ditching. The problem is investigated under the assumptions of an inviscid and incompressible fluid, which is modelled by a potential flow model with fully non-linear boundary conditions at the free-surface. The unsteady boundary value problem with a free-surface is numerically solved through a boundary element method, coupled to a simplified finite element method to describe the thinnest part of the jet. The study is aimed at describing the entry and exit phases. Specific numerical solutions are developed to tackle the exit phase and to improve the stability of the model. Results are presented in terms of free-surface shape, pressure distribution and hydrodynamic load acting on the impacting body. The model is used to study the water entry and exit of a 2D wedge and an axisymmetric cone, for which numerical or experimental results are available in the literature. The numerical investigation shows that the proposed model accurately simulate both the entry and exit phases. For the exit phase, it is shown that the proposed model, being fully non-linear, provides a much better prediction of the loads and the wetted area compared to simplified (analytical) approaches. The effects of the gravity, usually missing in the approaches available in the literature, are also investigated, showing they are rather important, especially, in the exit phase.

A Study of Formative and Continuous Models for Umbrella Water Curtain Based on Wall-Attaching Jets

Numerical Simulation of Two-Dimensional Dam Failure and Free-Side Deformation Flow Studies

Numerical Study of Violent Impact Flow Using a CIP-Based Model

A CIP-based Numerical Simulation of Wave Interaction with a Fluid-Filled Membrane Submerged Breakwater

Formulations of Hydrodynamic Force in the Transition Stage of the Water Entry of Linear Wedges with Constant and Varying Speeds

Multiphase Flow Simulation of Water Entry of a Structure with Complex Geometry Using a Three-Dimensional Parallel Compressible Model

A Numerical Study of Water Entry of Asymmetric Wedges Using a CIP-based Model

Theoretical and Experimental Study on the Water Curtain Shape and Mechanical Relationship of the Smoke Control System

A Numerical Study of a Submerged Water Jet Impinging on a Stationary Wall

Numerical Simulation Study of the Operating Characteristics of Attached-Wall Bistable Jet Elements

Measurements of water film thickness on a wing surface in simulated heavy rain

Water entry and exit of 2D and axisymmetric bodies

Numerical Simulation of Water Entry of Wedges in Waves Using A CIP-Based Model

Experimental study and modeling of water film thickness in aero-engine under air–water mist flow

Experimental and Numerical Analysis of the Fluid Flow Behavior of a Tank Corner Impacting a Water Surface

An Alternative Model for Simulating Water Between Two Monolayer Surfaces

A study of abrasive waterjet characteristics by CFD simulation

Investigating the entry of symmetric/asymmetric elastic wedge into water

Two-way coupled CFD-DEM model of a pre-mixed abrasive water jet and its application to the investigation of abrasive motion characteristics

A semi-analytical model of hydroelastic slamming

Numerical Investigation for Wall Film Flow Behaviors on Convex and Concave Surfaces of Curved Channel