Abstract:The two-phase loop thermosyphon (TPLT) is a highly efficient passive heat transfer device that is widely applied in various fields. This paper experimentally and numerically investigates the thermal response performance of a large-scale TPLT under various convective boundary conditions. Experimental studies have been carried out to explore the effects of different working fluids, filling ratios, cold and heat source temperatures, and mass flow rates on the thermosyphon's performance. Meanwhile, a two-dimensional Computational Fluid Dynamics (CFD) simulation model of the TPLT is established and validated. The results indicate that the start-up procedure of the TPLT is highly dependent on the heat source temperature and the working fluid. Normally, the TPLT can start when the heat source reaches a certain temperature. In general, using methanol as the working fluid is more favorable to start-up compared to the water and ethanol TPLTs. The experimental results also show that the heat transfer capacity of the TPLT increases with increasing heat source temperature while increasing cooling temperature decreases heat transfer capacity. The best heat transfer performance of a TPLT charging methanol is observed at a filling ratio of 70 % with a heating mass flow rate of 1 L/min. At that point, the convective heat transfer coefficient of outside the evaporator is 1036.7 W/(m 2 ·K). Moreover, the simulation results reveal that the average wall heat flux of the TPLT's evaporator initially decreases and then gradually stabilizes with time. During stable operation, the wall heat flux density of the evaporator exhibits an initial increase in the pool section followed by a subsequent decrease with increasing wall height. This work provides insight into the heat and fluid flow characteristics of the TPLT under convective boundary conditions.

Effect of reservoir on controllable loop thermosyphon

Experimental investigation on controllable loop thermosyphon with a reservoir

Preliminary Study on Variable Conductance Loop Thermosyphons

Experimental Study on the Temperature Management Behaviours of a Controllable Loop Thermosyphon

Characterisation Of A Controllable Loop Thermosyphon For Precise Temperature Management

Theoretical Analyses of a New Two-Stage Absorption-Transcritical Hybrid Refrigeration System

Utilization of Ultra-Low Temperature Heat by a Novel Cascade Refrigeration System with Environmentally-Friendly Refrigerants

Effect of non-condensable gas on the behaviours of a controllable loop thermosyphon under active control

Performance characteristics of variable conductance loop thermosyphon for energy-efficient building thermal control

Experimental study on the passive regulation of a CO2 two-phase thermosyphon loop

Performance Evaluation of Controllable Separate Heat Pipes

Experimental study of a novel cool-storage refrigerator with controllable two-phase loop thermosyphon

Experimental Study on the Effect of Fill Ratio on an R744 Two-Phase Thermosyphon Loop

Experimental study on thermal characteristics of thermosyphon with water condenser and LTES condenser in parallel (TWCLC)

Numerical Analysis of a Novel Household Refrigerator with Controllable Loop Thermosyphons

Experimental study on the effect of filling ratio on an R141b two-phase thermosyphon loop with a horizontal parallel tube evaporator

Investigation of the thermal response characteristics of the loop thermosyphon under convective boundary conditions

Thermal characteristics of a two-phase loop thermosyphon with micro-grooved structures inside the evaporator

Experimental and theoretical analysis of a closed loop two-phase thermosiphon under various states for latent heat storage

CFD simulation on the operation characteristics of CO 2 two-phase thermosyphon loop

Experimental Analysis of a Fin-Enhanced Three-Tube-shell Cascaded Latent Heat Storage System