Abstract:For the battery- or USB-powered portable smart devices, which supply their computing cores with a wide-range sub-volt rail, the energy-efficient high and wide voltage-conversion-ratio (VCR) converters are crucially important. In addition, low form factor and decent transient responses are also favorable for such applications. Prior state-of-the-art designs either use single-stage hybrid designs using multi-level or Dickson converters [1 – 3], or adopt two-stage cascaded architectures with a highly efficient unregulated front (or rear) stage [4], as shown in Fig. 18.6.1 (left). The multi-level designs, which conduct the full inductor current through all the on-state switches, are suited to low-to-medium power levels with limited current density. The Dickson converters take advantage of a high conversion ratio, however, at the cost of reduced output voltage range. The two-stage designs which show decent output range and efficiency, however, can suffer from heavy load efficiency degradation considering that the efficiency of both stages degrade with increasing load and the overall efficiency which is the product of the efficiencies of the two stages is severely degraded. Inspired by the inductive-sigma converter [5] which shunts a highly efficient unregulated LLC with a regulated Buck, this work proposes a reconfigurable capacitive-sigma converter. By input-series and output-shunting a highly efficient unregulated switched-capacitor (SC) converter with a reconfigurable Dickson hybrid Buck stage, the power stage input current is reused and output currents are combined. Therefore, the overall efficiency is greatly improved in a wide continuous VCR range and with an enhanced loading capacity. Besides, as will be demonstrated, the proposed design shows inherently decent load transient and regulation performances.

An Energy-Efficient, Adaptive Voltage Scaling Output Stage for Neural Stimulators Based on Sepic Converter

A High-Voltage, Energy-Efficient, 4-Electrode Output Stage for Implantable Neural Stimulator

Design Of High Accuracy High Conversion Ratio Single-Stage Switching Power Converter For Modern Fpgas At 10mhz

An Energy-Efficient Implantable-Neural-Stimulator System with Wireless Charging and Dynamic Voltage Output.

A 4-Channel Neural Stimulation IC Design with Charge Balancing and Exponential Current Output

A Dual-Mode Neural Stimulator with Two-Step Charge Balancing Scheme for Fast Residual Voltage Compensation

A High-Voltage-Compliant 86% Peak Efficiency Current-Mode Stimulator with Dynamic Voltage Supply for Implantable Medical Devices

An energy-efficient, adiabatic electrode stimulator with inductive energy recycling and feedback current regulation

An Energy-Efficient High-Frequency Neuro-Stimulator with Parallel Pulse Generators, Staggered Output and Extended Average Current Range.

A Power-Efficient Current-Mode Neural/Muscular Stimulator Design For Peripheral Nerve Prosthesis

A 4-Channel Neural Stimulation IC Design with Charge Balancing and Multiple Current Output Modes

An Integrated Implantable Stimulator That is Fail-Safe Without Off-Chip Blocking-Capacitors

A 15.7-V-Compliant 86% Peak Efficiency Current-Mode Stimulator With Dynamic Voltage Supply for Implantable Medical Devices

A Scalable, Programmable Neural Stimulator for Enhancing Generalizability in Neural Interface Applications

A Multi-Channel Stimulator With High-Resolution Time-to-Current Conversion for Vagal-Cardiac Neuromodulation

An electrode-impedance-aware neurostimulator IC that achieves low-power consumption and fast charge balance

A 5V Input 98.4% Peak Efficiency Reconfigurable Capacitive-Sigma Converter with Greater Than 90% Peak Efficiency for the Entire 0.4~1.2V Output Range.

An Energy-Efficient Wireless Power Receiver with One-Step Adiabatic-Bipolar-Supply Generating for Implantable Electrical Stimulation Applications

Design of a Net-Zero Charge Neural Stimulator with Feedback Control.

A PMOS-based Programmable Stimulator with Adaptive Charge Pump for Cardiac Pacemakers