Abstract:This work investigates jet impingement of heated steel plate using an industrial scale run‐out tables (ROT) facility with thermal camera. A mixture Eulerian fluid dynamics (CFD), and heat transfer model is developed to obtain the boiling curves numerically. The microstructure characteristics and the properties of rolled steels are significantly affected by the heat transfer and boiling phenomena occurring during the jet impingement cooling on run‐out tables (ROT). In this study, experiments are conducted using a full industrial‐scale ROT facility with rectangular plates made of low‐carbon stainless steel (type 316L). The plate is heated up to a temperature ranging from 500 to 900 °C, then rapidly impinged using a single circular water jet, and the temperature drop is captured using an infrared thermal camera (FLIR A615 25°–50 Hz type). The dissipated heat flux, estimated experimentally using a 2D inverse heat conduction analysis, ranges from 6.1 to 3.4 MW m−2 across different zones along the plate surface. The impact of different initial plate temperature on the boiling behavior is studied by developing a 2D‐computational fluid dynamics (CFD) model, and the results are closely aligned with the experimental findings. The results reveal that when estimating the heat flux from CFD simulations, the best accuracy is obtained when considering fluid temperature at a point close to the plate surface (about 1 μm above the surface). Furthermore, the maximum extracted heat flux (MHF) is significantly influenced by the initial temperature of the plate. Increasing the initial plate temperature from 500 to 900 °C led to an increase of 82% in the MHF in stagnation zone, and 137% increase in the parallel‐flow region. The CFD model presented in this study and the full calculation of the boiling curves numerically will pave the road for investigating various practical parameters in jet impingement cooling.

Infrared camera-based analysis of heat flux distribution in film boiling of water flow over a moving steel sheet

Surface heat flux of upward circular water jet impingement on a moving hot steel sheet

Subcooled Pool Film Boiling Heat Transfer from Spheres with Superhydrophobic Surfaces: an Experimental Study

Evaluation of Heat Conduction and Visualization of Heat Flux in a Plate Making Use of Heat Transfer Experiments

Experimental study of bubble behaviors and heat transfer coefficient on hot steel balls during deionized water pool boiling

Experimental Design and Analysis for Film Boiling Heat Transfer in a Circular Tube

Experiments on heat transfer of smooth and swirl tubes under one-sided heating conditions

Thermal Imaging Study of Falling Liquid Films

Study of Heat Transfer Coefficients of Multiple High-Pressure Fan-Shaped Water Impinging on the Lower Surface of High-Temperature Steel Billets

Numerical Simulation On Heat Transfer Of Falling Film Flow Along A Vertical Wall

Thermal Imaging Study on the Surface Wave of Heated Falling Liquid Films

ICONE23-1135 EXPERIMENTAL INVESTIGATION ON THE WATER FILM BEHAVIOR WITH COUNTER-CURRENT AIR FLOW

A Study on the Heat Transfer Characteristics of Steel Plate in the Matrix Laminar Cooling Process

Experimental Investigation of the Film Boiling Heat Transfer in Heii: Heat Transfer Coefficient

Heat Transfer from a Hot Steel Plate Impinged by Air-atomized Water Jet and Impinging Water Jet

Study on Film Boiling Heat Transfer for Water Jet Impinging on High Temperature Flat Plate

Experimental study in steady-state for determining the coefficient of external heat transfer on the outer wall of rotating tubes during the quenching process by immersion in water tank

Investigation on Heat Transfer of In-Tube Supercritical Water Cooling Accompanying Out-Tube Pool Boiling

Study of the Effect of Initial Plate Temperature in Jet Impingement Cooling Process

Conjugate Heat Transfer Analysis of Film Cooling Flows

Wetting layer evolution and interfacial heat transfer in water-air spray cooling process of hot metallic surface