Abstract:This paper presents the implementation and verification of a dual-probe measurement system with a novel method and easily integrated chromatic confocal probes, for synchronous evaluation of not only the inner and outer cylindricity but also the thickness distribution of a ring-type cylinder. A pair of measuring probes mounted on a four-axis scanning stage, which is composed of XYZ-slides and a spindle, is utilized to target the two sides of the ring-type cylinder. In the developed system, to reduce the influence of the positioning errors and tilt misalignments of the confocal probes and the cylinder, alignment methods are developed. The outputs of the measuring probes are employed to accurately evaluate the geometric errors of the ring-type cylinder through performing spiral scanning while separating the Z-slide and spindle motion errors of the scanning stage based on a reversal error separation method. To verify the performance of the proposed system and method, the geometric errors of a thin-walled cylinder which has a nominal outer diameter of 50 mm, an inner diameter of 40 mm, and a length of 100 mm are evaluated in experiments. The experimental results are further compared with those by a coordinate measuring machine (CMM), and the high correspondence of the comparison results well confirm the feasibility of the implemented measurement system. Finally, measurement uncertainty analysis is conducted to demonstrate the reliability of the proposed method for the evaluation of the geometric errors of ring-type cylinders. The measurement accuracy is comparable to that of a CMM.

Determination of geometrical deviations of large crankshafts depending on the adopted conditions of their fixing and support

Eliminating the Influence of Support Conditions on Geometric Shape Measurements of Large Crankshafts of Marine Engines

Method to Increase the Accuracy of Large Crankshaft Geometry Measurements Using Counterweights to Minimize Elastic Deformations

An Analysis of Reaction Forces in Crankshaft Support Systems

Evaluation of Model-based Control of Reaction Forces at the Supports of Large-size Crankshafts

Analysis of Contact Deformations in Support Systems Using Roller Prisms

Computerised grinding procedure for large scale crankshaft machining

STUDY OF THE GEOMETRY OF GRINDING MACHINES USED FOR LARGE SCALE CRANKSHAFT MACHINING

Implementation and Verification of a Dual-Probe Measurement System for Geometric Form Evaluation of a Ring-Type Cylinder

Determination on the Operation Condition of Crankshaft of Diesel Engine and Its Static Strength Analysis

Precise Alignment Method of the Large-Scale Crankshaft During Non-Circular Grinding

Accurate Inner Profile Measurement of a High Aspect Ratio Aspheric Workpiece Using a Two-Probe Measuring System

Full-scale Measurement of CNC Machine Tools

Study on the Measurement of Global Sizes of Cylindrical Parts Using Talyrond 585LT.

Air conditioning compressor crankshaft roundness measurement based on a laser profiler

Research on straightness error detection and quality control of multi-crankshaft bores for large medium speed engine block

Research on the measurement method of crankshaft coaxiality error based on three-dimensional point cloud

A Method for Measuring Shaft Diameter Based on Light Stripe Image Enhancement

Online approach to measuring relative location of spatial geometric features of long rotating parts

Comparison between the strength of steel and cast iron crankshafts in large-scale routine fatigue bending tests